Abstract:Silicon carbide (SiC) devices have the potential to yield new components with functional capabilities that far exceed components based on silicon devices. Selective doping of SiC by ion implantation is an important fabrication technology that must be completely understood if SiC devices are to achieve their potential. One major problem with ion implantation into SiC is the surface roughening that results from annealing SiC at the high temperatures which are needed to activate implanted acceptor ions, boron or aluminum. This paper examines the causes and possible solutions to surface roughening of implanted and annealed 4H-SiC. Samples consisting of n-type epilayers (5 × 1015 cm−3, 4 µm thick) on 4H-SiC substrates were implanted with B or Al to a total dose of 4 × 1014 cm−2 or 2 × 1015 cm−2, respectively. Roughness measurements were made using atomic force microscopy. From the variation of root mean square (rms) roughness with annealing temperature, apparent activation energies for roughening following implantation with Al and B were 1.1 and 2.2 eV, respectively, when annealed in argon. Time-dependent activation and surface morphology analyses show a sublinear dependence of implant activation on time; activation percentages after a 5 min anneal following boron implantation are about a factor of two less than after a 40 min anneal. The rms surface roughness remained relatively constant with time for anneals in argon at 1750°C. Roughness values at this temperature were approximately 8.0 nm. Annealing experiments performed in different ambients demonstrated the benefits of using silane to maintain good surface morphology. Roughnesses were 1.0 nm (rms) when boron or aluminum implants were annealed in silane at 1700°C, but were about 8 and 11 nm for B and Al, respectively, when annealed in argon at the same temperature.

Surface microstructure and wetting of SiC ceramic modified by ion bombardment

Wetting behavior of Al on the surface of SiC textured by nanosecond laser

Synthesis of silicon carbide films by combined implantation with sputtering techniques

Surface modification and structure evolution of aluminum under argon ion bombardment

Nano-cutting mechanism of ion implantation-modified SiC: reducing subsurface damage expansion and abrasive wear

Preparation, microstructure and ion-irradiation damage behavior of Al4SiC4-added SiC ceramics

Fabricating physicochemical microstructures with super hydrophilicity on Cf/SiC composites surface via picosecond-laser induced ablation

Structure and fracture behavior of ion-beam-modified SiC-Al2O3-ZrO2 ceramic composites

Nanostructure formation of Cu/Si(100) thin film induced by ion beam bombardment

Ag Ion Beam Irradiation Modification of Si and SiO2 Surfaces

Ion-irradiation effect on swelling and microstructure of BN particle dispersed liquid phase sintering SiC

Surface modification of superfine SiC powders by ternary modifiers-KH560/sodium humate/SDS and its mechanism

Femtosecond laser modification of silicon carbide substrates and its influence on CMP process

Surface roughening in ion implanted 4H-silicon carbide

Silicon Carbide Wafer Polishing With Gas Cluster Ion Beams

Using in-situ conversed nano SiC to bond UHTC particles and construct anti-ablation coating

Evaluation of structure-chemistry coupling effects for superwetting silicon carbide by laser-based functionalization

Effect of temperature-dependent nano SiC on the ablation resistance of ZrC coating

Effects of ion irradiation on microstructures and mechanical properties of SiOC nanocomposites

Friction and wear behavior of C implanted copper via ion beam-assisted bombardment

Fabrication and functional characteristics of micro/nano structures on the RB-SiC surface through nanosecond pulsed laser irradiation