Abstract:Barium titanate (BaTiO3, hereafter BT) is an established ferroelectric material first discovered in the 1940s and still widely used because of its well-balanced ferroelectricity, piezoelectricity, and dielectric constant. In addition, BT does not contain any toxic elements. Therefore, it is considered to be an eco-friendly material, which has attracted considerable interest as a replacement for lead zirconate titanate (PZT). However, bulk BT loses its ferroelectricity at approximately 130 °C, thus, it cannot be used at high temperatures. Because of the growing demand for high-temperature ferroelectric materials, it is important to enhance the thermal stability of ferroelectricity in BT. In previous studies, strain originating from the lattice mismatch at hetero-interfaces has been used. However, the sample preparation in this approach requires complicated and expensive physical processes, which are undesirable for practical applications. In this study, we propose a chemical synthesis of a porous material as an alternative means of introducing strain. We synthesized a porous BT thin film using a surfactant-assisted sol-gel method, in which self-assembled amphipathic surfactant micelles were used as an organic template. Through a series of studies, we clarified that the introduction of pores had a similar effect on distorting the BT crystal lattice, to that of a hetero-interface, leading to the enhancement and stabilization of ferroelectricity. Owing to its simplicity and cost effectiveness, this fabrication process has considerable advantages over conventional methods.

Low-Temperature Synthesis of Barium Titanate in a Mesoporous Polyethylene Matrix

Low-temperature synthesis of barium titanate in the mesoporous polyethylene matrices

Low-temperature synthesis of barium titanate thin films by nanoparticles electrophoretic deposition

Synthesis of Highly Dispersed Barium Titanate Nanoparticles by a Novel Solvothermal Method

LOW-TEMPERATURE SYNTHESIS OF BARIUM TITANITE IN AQUEOUS SOLUTION

Synthesis of Barium Titanate/polymer Composites from Metal Alkoxide

Hydrothermal Synthesis of Tetragonal Barium Titanate Nanopowders under Moderate Conditions

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Low-temperature Synthesis and Analysis of Barium Titanate Nanoparticles with Excess Barium

Study of Structural and Photoluminescent Properties in Barium Titanate Nanocrystals Synthesized by Hydrothermal Process

Preparation of A Monodispersed Suspension of Barium Titanate Nanoparticles and Electrophoretic Deposition of Thin Films

Direct Synthesis of Barium Zirconate Titanate (BZT) Nanoparticles at Room Temperature and Sintering of Their Ceramics at Low Temperature

Low Temperature Hydrothermal Synthesis and Performances of Nanotube Patterned Barium Titanates Thin Films

Horizontally-oriented barium titanate@polydomine/polyimide nanocomposite films for high-temperature energy storage

Improvement in Dielectric Properties of Barium Titanate/Polypropylene Nanocomposites Via Surface Modification of Ceramic Nanoparticles

Low-temperature Synthesis of Nano-Crystalline Magnesium Titanate Materials by the Sol–gel Method

Synthesis of Single-Crystalline Barium Dititanate Nanobelts

Fabrication of Highly Dispersed Crystallized Nanoparticles of Barium Strontium Titanate in the Presence of N,N-dimethylacetamide

Chemical Synthesis of Porous Barium Titanate Thin Film and Thermal Stabilization of Ferroelectric Phase by Porosity-Induced Strain

In situ synthesis of nanocrystalline BaTiO 3 particle–polymer hybrid

In situ synthesis of nanocrystalline BaTiO<sub>3</sub> particle–polymer hybrid