Abstract:Barium titanate (BaTiO3, hereafter BT) is an established ferroelectric material first discovered in the 1940s and still widely used because of its well-balanced ferroelectricity, piezoelectricity, and dielectric constant. In addition, BT does not contain any toxic elements. Therefore, it is considered to be an eco-friendly material, which has attracted considerable interest as a replacement for lead zirconate titanate (PZT). However, bulk BT loses its ferroelectricity at approximately 130 °C, thus, it cannot be used at high temperatures. Because of the growing demand for high-temperature ferroelectric materials, it is important to enhance the thermal stability of ferroelectricity in BT. In previous studies, strain originating from the lattice mismatch at hetero-interfaces has been used. However, the sample preparation in this approach requires complicated and expensive physical processes, which are undesirable for practical applications. In this study, we propose a chemical synthesis of a porous material as an alternative means of introducing strain. We synthesized a porous BT thin film using a surfactant-assisted sol-gel method, in which self-assembled amphipathic surfactant micelles were used as an organic template. Through a series of studies, we clarified that the introduction of pores had a similar effect on distorting the BT crystal lattice, to that of a hetero-interface, leading to the enhancement and stabilization of ferroelectricity. Owing to its simplicity and cost effectiveness, this fabrication process has considerable advantages over conventional methods.

Low-temperature synthesis of barium titanate in the mesoporous polyethylene matrices

Low-Temperature Synthesis of Barium Titanate in a Mesoporous Polyethylene Matrix

Low-temperature synthesis of barium titanate thin films by nanoparticles electrophoretic deposition

LOW-TEMPERATURE SYNTHESIS OF BARIUM TITANITE IN AQUEOUS SOLUTION

Synthesis of Highly Dispersed Barium Titanate Nanoparticles by a Novel Solvothermal Method

Synthesis of Barium Titanate/polymer Composites from Metal Alkoxide

Low-temperature Synthesis and Analysis of Barium Titanate Nanoparticles with Excess Barium

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Hydrothermal Synthesis of Tetragonal Barium Titanate Nanopowders under Moderate Conditions

Low-temperature Synthesis of Highly Dispersed Barium Aluminate

Improvement in Dielectric Properties of Barium Titanate/Polypropylene Nanocomposites Via Surface Modification of Ceramic Nanoparticles

Study of Structural and Photoluminescent Properties in Barium Titanate Nanocrystals Synthesized by Hydrothermal Process

Low Temperature Hydrothermal Synthesis and Performances of Nanotube Patterned Barium Titanates Thin Films

Synthesis and characterization of nanocrystalline barium strontium titanate powder by a modified sol-gel processing

Horizontally-oriented barium titanate@polydomine/polyimide nanocomposite films for high-temperature energy storage

Direct Synthesis of Barium Zirconate Titanate (BZT) Nanoparticles at Room Temperature and Sintering of Their Ceramics at Low Temperature

Methods for the synthesis of barium titanate as a component of functional dielectric ceramics

Sol–gel Synthesis of Macroporous Barium Zirconate Monoliths from Ionic Precursors Via a Phase Separation Route

High energy density nanocomposites based on poly(vinylidene fluoride-chlorotrifluoroethylene) and barium titanate

Chemical Synthesis of Porous Barium Titanate Thin Film and Thermal Stabilization of Ferroelectric Phase by Porosity-Induced Strain

Dielectric spectroscopy of nano BaTiO3 confined in MCM-41 mesoporous molecular sieve materials