Abstract:In the past decades, Zirconia (ZrO2) has emerged as a promising technical ceramic, both as high temperature structural material and electrolyte for fuel cells, etc. The traditional synthesis of ZrO2 with spark plasma sintering (SPS) usually requires a sintering temperature as high as 1200 °C. General interest in lowering the sintering temperature to reduce energy consumption and thermal stresses has led to research on two promising routes – cold sintering via temperature-dependent chemical reactivity and sintering aids, which facilitates mass transport and improves densification. Here we combine both by developing a single-step sintering process benefitting from both water vapor through the in-situ conversion of Zr(OH)4 to ZrO2 and liquid phase Bi2O3 as a sintering aid. The resultant ZrO2 has a relative density above 80% with a sintering temperature as low as 900 °C, significantly higher than that of ZrO2 without sintering aids, which had a relative density of 54%, both sintered at 50 MPa. The dependence of porosity of sintered samples as a function of sintering pressure (range: 50 MPa–300 MPa) and temperature (range 400 °C–1200 °C) is mapped out as guidance for further material property design. A linear relationship between hardness and relative density was found, with a maximal hardness of 6.6 GPa achieved in samples with 30% porosity. In addition to sintered density, phase stabilization of tetragonal ZrO2 is enhanced at sintering temperature of 900 °C with water vapor and Bi2O3, respectively.

Direct Synthesis of Barium Zirconate Titanate (BZT) Nanoparticles at Room Temperature and Sintering of Their Ceramics at Low Temperature

Room Temperature Synthesis of Barium Zirconate Titanate Nanopowders and Their Sintering Characteristics

A New Sintering Approach to Ceramics at Low Temperature from Ba(Zr X Ti 1- X )O 3 Nanoparticles Doped by ZnO

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Low-temperature Synthesis of TiB2 Nanocrystals Using TiO2 ,LiBH4 and Mg

Direct Synthesis of Ultrafine Tetragonal BaTiO3 Nanoparticles at Room Temperature

Synthesis and Characterization of Ba(Zr0.15Ti0.85)O3 Nano Powders by Oxalate Precipitation Method

Low-Temperature Sintering of Bi(Ni0.5Ti0.5)O3-BiFeO3-Pb(Zr0.5Ti0.5)O3 Ceramics and Their Performance

Very-low temperature synthesis of pure and crystalline lead-free Ba0.85Ca0.15Zr0.1Ti0.9O3 ceramic

Synthesis of Nanocrystalline 0.94Bi<sub>0.5</sub>Na<sub>0.5</sub>TiO<sub>3</sub>-0.06BaTiO<sub>3</sub> Powder by a Citrate Method

Low-temperature preparation of nanoplated bismuth titanate microspheres by a sol–gel-hydrothermal method

Influence of bismuth oxide as a sintering aid on the densification of cold sintering of zirconia

Effect of sintering temperature on the microstructure and electrical properties of zirconium doped barium titanate ceramics

Hydrothermal Synthesis of Tetragonal Barium Titanate Nanopowders under Moderate Conditions

Low-temperature Sintering and Microwave Dielectric Properties of BaO–0.15ZnO–4TiO 2 Ceramics with Li 2 O–B 2 O 3 –sio 2 Addition

Controllable synthesis of (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3 submicron sphere by hydroxide co-precipitation method

Low Temperature Sintering and Dielectric Properties of BaTi_(0.75)Zr_(0.25)O_3 Ceramic

Study on barium zirconate titanate nano powders prepared by oxalate precipitation method

Direct large-scale synthesis of perovskite barium strontium titanate nano-particles from solutions

Synthesis of Nanocrystalline 0.94Bi(0.5)na(0.5)tio(3)-0.06Batio(3) Powder by A Citrate Method

Synthesis and characterization of nanocrystalline PZT powders by a simple sol-gel method