Characterization and Modeling of Commercial ICs for System-Efficient ESD Design
Zhekun Peng,Yang Xu,Manje Yea,Sergej Bub,Steffen Holland,DongHyun Kim,David Pommerenke,Daryl G. Beetner
DOI: https://doi.org/10.1109/TEMC.2022.3217749
IF: 2.036
2022-01-01
IEEE Transactions on Electromagnetic Compatibility
Abstract:Optimizing electrostatic discharge (ESD) protection strategies requires simulation models of both
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small>
- and
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small>
-die ESD devices, but detailed information about
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small>
-die ESD protection is rarely available. Methods are proposed in the following paper to characterize and model the
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small>
-chip ESD protection using only measurements, with minimal
<italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">a priori</i>
information about how the protection is implemented. The characterization targets a three-terminal (rather than the traditional two-terminal) protection structure, including the I/O, Vdd, Vss pins, and allows for current to flow between multiple pins simultaneously. A previously-developed behavioral model for TVS devices is used to capture the ESD behavior of the integrated circuit (IC), including its linear, quasi-static, and transient nonlinear response. The approach is used to model the equivalent current that flows through the
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small>
-chip ESD protection of two commercial ICs. The model of the
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small>
-chip ESD protection is combined with a behavioral model of an
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small>
-chip transient voltage suppressor to demonstrate their combined performance in a system-efficient ESD design (SEED) simulation. The model is validated both when the IC is powered-
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small>
and powered-
<sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small>
. The SEED model was able to predict quasistatic and peak voltages and currents at the IC with less than a 10% error.