Abstract:Al/SiC composites with volume fractions of SiC between 0.55 and 0.71 were made from identical tapped and vibrated powder preforms by squeeze casting (SC) and by two different setups for gas pressure infiltration (GPI), one that allows short (1–2 min) liquid metal/ceramic contact time (fast GPI) and the other that operates with rather long contact time, i.e., 10–15 min, (slow GPI). Increased liquid metal–ceramic contact time is shown to be the key parameter for the resulting thermal and electrical conductivity in the Al/SiC composites for a given preform. While for the squeeze cast samples neither dissolution of the SiC nor formation of Al4C3 was observed, the gas pressure assisted infiltration led inevitably to a reduced electrical and thermal conductivity of the matrix due to partial decomposition of SiC leading to Si in the matrix. Concomitantly, formation of Al4C3 at the interface was observed in both sets of gas pressure infiltrated samples. Longer contact times lead to much higher levels of Si in the matrix and to more Al4C3 formation at the interface. The difference in thermal conductivity between the SC samples and the fast GPI samples could be rationalized by the reduced matrix thermal conductivity only. On the other hand, in order to rationalize the thermal conductivity of the slow GPI a reduction in the metal/ceramic interface thermal conductance due to excessive Al4C3-formation had to be invoked. The CTE of the composites generally tended to decrease with increasing volume fraction of SiC except for the samples in which a large expansive drift was observed during the CTE measurement by thermal cycles. Such drift was essentially observed in the SC samples with high volume fraction of SiC while it was much smaller for the GPI samples.

Effects of solid solution, grain size and porosity on the thermal conductivity of aluminum- and boron-added porous silicon carbide ceramics with in-situ grain growth

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Effects of boron source on properties of pressureless solid-state sintered silicon carbide ceramics

Characterization and modeling of the temperature-dependent thermal conductivity in sintered porous silicon-aluminum nanomaterials

Mechanical properties and thermal shock resistance of Si2BC3N ceramics with ternary Al4SiC4 additive

Effect of Silicon Addition and Thermal History on the Thermal Expansion Behavior of Sic/Al Composites

Effect of pore structure evolution on mechanical properties and thermal conductivity of porous SiC-Mullite ceramics

Effects of pore size on electrical and thermal properties of porous SiC ceramics

Effects of AlN Content and Sintering Atmospheres on the Thermal Conductivity of Hot-Pressed SiC Ceramics

High Thermal Conductivity in Pressureless Densified SiC Ceramics with Ultra-Low Contents of Additives Derived from Novel Boron–carbon Sources

Effects of Sintering Additives on the Thermoelectric Properties of SiC Ceramics

Influence of Grain Size on Thermal Conductivity of SiC Ceramics

A Quantitative Study on the Interaction Between Silicon Content and Heat Treatment on Thermal Conductivity of Al-Si Binary Alloys

Exploration of an atomic‐scale boron additive in SiAlON ceramics

Pressureless sintering of boron carbide ceramics with Al–Si additives

Effect of Porosity on the Structure and Properties of Β-Sialon Ceramics

Effects of pore structure on thermal conductivity and strength of alumina porous ceramics using carbon black as pore-forming agent

Influence of processing route on electrical and thermal conductivity of Al/SiC composites with bimodal particle distribution

B4C-SiC composites with tuneable mechanical properties: Role of Al2O3 - Y2O3 sintering additives

Thermal conductivity improvement in Si3N4 ceramics via grain purification

Effect of Activator on Properties of SiC Porous Ceramics