Abstract:Digital light processing (DLP) is a promising additive manufacturing method for creating complex structural alumina ceramic with high precision, high efficiency, and low cost. However, printing large-size parts with high feature resolution by DLP, obtaining high-performance pastes, and optimizing the debinding process are challenges that still need to be overcome. In this study, an advanced top-down Matrix-DLP technology that seamlessly connects two high-definition-resolution DLP projectors, with high resolution and a large projection area, was used to achieve fine-structured large-size alumina green bodies. The homogeneous and stable non-self-levelling alumina pastes suitable for the DLP technology were developed, with a high solid loading up to 55 vol%, viscosity of 35.0 Pa s at 30 s−1, and good rheological properties by innovatively using 2.5 wt% P5318 as surface modifiers of alumina powders and with only a 0.244% volume of bubble residue by using 0.5 wt% BYK-066N defoamer in combination with a vacuum planetary stirring defoaming process. The debinding processes were designed based on TG-DSC analysis and then optimized, and it was proved that the segmented-atmosphere debinding process was the best approach and can obtain defect- and carbon residue-free bodies with uniform grain distribution, and can also achieve non-destructive debinding for the thick-walled parts with thickness greater than 10 mm. The effects of the debinding residual carbon and the solid loading on the microstructure and properties after sintering were also investigated. Consequently, the high-precision large-size alumina ceramic with good interlayer bonding, dense microstructure, and high microhardness of 17.92 GPa was obtained.

Study of alumina ceramic parts fabricated via DLP stereolithography using powders with different sizes and morphologies

Preparation of large-size alumina ceramic parts by DLP 3D printing using high-solid-loading paste and optimizing the debinding process

Optimization of 3D Printing Parameters for Alumina Ceramic Based on the Orthogonal Test

Inter-particle interactions of alumina powders in UV-curable suspensions for DLP stereolithography and its effect on rheology, solid loading, and self-leveling behavior

Relationship between the adhesion properties of UV-curable alumina suspensions and the functionalities and structures of UV-curable acrylate monomers for DLP-based ceramic stereolithography

Fabrication and properties of alumina ceramics shaped by digital light processing as an additive manufacturing technology

Rheological behavior and curing deformation of paste containing 85 wt% Al2O3 ceramic during SLA-3D printing

Numerical Simulation of Sintering of DLP Printed Alumina Ceramics

Reinforcement effect in printing precision and sintering performance for liquid crystal display stereolithography additive manufacturing of alumina ceramics

Effect of particle size distribution and printing parameters on alumina ceramics prepared by Additive Manufacturing

Influence of resin composition on rheology and polymerization kinetics of alumina ceramic suspensions for digital light processing (DLP) additive manufacturing

Polycrystalline alumina ceramic fabrication using digital stereolithographic light process

Preparation of high performance dense Al 2 O 3 ceramics by digital light processing 3D printing technology

Formation mechanism and controlling strategy of lamellar structure in 3D printed alumina ceramics by digital light processing

Digital light processing‐based additive manufacturing of orientation‐controlled Al2O3 ceramics with improved damage tolerance

High‐Quality Translucent Alumina Ceramic Through Digital Light Processing Stereolithography Method

Additive Manufacturing and Characterization of Complex Al2o3 Parts Based on A Novel Stereolithography Method

Fabrication of alumina ceramics with high flexural strength using stereolithography

Fabrication of fine and complex lattice structure Al2O3 ceramic by digital light processing 3D printing technology

Effect of parameters on 3D printing of alumina ceramics and evaluation of properties of sintered parts

Microstructures and mechanical properties of additively manufactured alumina ceramics with digital light processing