Abstract:Digital light processing (DLP) is a promising additive manufacturing method for creating complex structural alumina ceramic with high precision, high efficiency, and low cost. However, printing large-size parts with high feature resolution by DLP, obtaining high-performance pastes, and optimizing the debinding process are challenges that still need to be overcome. In this study, an advanced top-down Matrix-DLP technology that seamlessly connects two high-definition-resolution DLP projectors, with high resolution and a large projection area, was used to achieve fine-structured large-size alumina green bodies. The homogeneous and stable non-self-levelling alumina pastes suitable for the DLP technology were developed, with a high solid loading up to 55 vol%, viscosity of 35.0 Pa s at 30 s−1, and good rheological properties by innovatively using 2.5 wt% P5318 as surface modifiers of alumina powders and with only a 0.244% volume of bubble residue by using 0.5 wt% BYK-066N defoamer in combination with a vacuum planetary stirring defoaming process. The debinding processes were designed based on TG-DSC analysis and then optimized, and it was proved that the segmented-atmosphere debinding process was the best approach and can obtain defect- and carbon residue-free bodies with uniform grain distribution, and can also achieve non-destructive debinding for the thick-walled parts with thickness greater than 10 mm. The effects of the debinding residual carbon and the solid loading on the microstructure and properties after sintering were also investigated. Consequently, the high-precision large-size alumina ceramic with good interlayer bonding, dense microstructure, and high microhardness of 17.92 GPa was obtained.

Fabrication of fine and complex lattice structure Al2O3 ceramic by digital light processing 3D printing technology

Preparation of high performance dense Al 2 O 3 ceramics by digital light processing 3D printing technology

Preparation of excellent performance ZTA ceramics and complex shaped components using digital light processing 3D printing technology

Microstructures and mechanical properties of additively manufactured alumina ceramics with digital light processing

POLYMER-DERIVED SIC CERAMIC WITH TRIPLY PERIOD MINIMAL SURFACE STRUCTURE FABRICATION THROUGH DIGITAL LIGHT PROCESSING

Fabrication and properties of alumina ceramics shaped by digital light processing as an additive manufacturing technology

Preparation of large-size alumina ceramic parts by DLP 3D printing using high-solid-loading paste and optimizing the debinding process

Microstructure refinement-homogenization and flexural strength improvement of Al2O3 ceramics fabricated by DLP-stereolithography integrated with chemical precipitation coating process

High‐Quality Translucent Alumina Ceramic Through Digital Light Processing Stereolithography Method

Digital light processing 3D printing of ceramic shell for precision casting

Fine lattice structural titanium dioxide ceramic produced by DLP 3D printing

Additive manufacturing of Al2O3 ceramic core with applicable microstructure and mechanical properties via digital light processing of high solid loading slurry

Formation mechanism and controlling strategy of lamellar structure in 3D printed alumina ceramics by digital light processing

High-performance and high-precision Al2O3 architectures enabled by high-solid-loading, graphene-containing slurries for top-down DLP 3D printing

Fabrication and mechanical properties of triply period minimal surface porous alumina ceramics based on Digital Light Processing 3D printing technology

3D printing of hollow lattice structures of ZrO2(3Y)/Al2O3 ceramics by vat photopolymerization: Process optimization, microstructure evolution and mechanical properties

Digital light processing‐based additive manufacturing of orientation‐controlled Al2O3 ceramics with improved damage tolerance

Reinforcement effect in printing precision and sintering performance for liquid crystal display stereolithography additive manufacturing of alumina ceramics

Additive Manufacturing and Characterization of Complex Al2o3 Parts Based on A Novel Stereolithography Method

Fabrication and characterisation of ceramics via low-cost DLP 3D printing

Preparation and properties of Si3N4 ceramics via digital light processing using Si3N4 powder coated with Al2O3-Y2O3 sintering additives