Abstract:Digital light processing (DLP) is a promising additive manufacturing method for creating complex structural alumina ceramic with high precision, high efficiency, and low cost. However, printing large-size parts with high feature resolution by DLP, obtaining high-performance pastes, and optimizing the debinding process are challenges that still need to be overcome. In this study, an advanced top-down Matrix-DLP technology that seamlessly connects two high-definition-resolution DLP projectors, with high resolution and a large projection area, was used to achieve fine-structured large-size alumina green bodies. The homogeneous and stable non-self-levelling alumina pastes suitable for the DLP technology were developed, with a high solid loading up to 55 vol%, viscosity of 35.0 Pa s at 30 s−1, and good rheological properties by innovatively using 2.5 wt% P5318 as surface modifiers of alumina powders and with only a 0.244% volume of bubble residue by using 0.5 wt% BYK-066N defoamer in combination with a vacuum planetary stirring defoaming process. The debinding processes were designed based on TG-DSC analysis and then optimized, and it was proved that the segmented-atmosphere debinding process was the best approach and can obtain defect- and carbon residue-free bodies with uniform grain distribution, and can also achieve non-destructive debinding for the thick-walled parts with thickness greater than 10 mm. The effects of the debinding residual carbon and the solid loading on the microstructure and properties after sintering were also investigated. Consequently, the high-precision large-size alumina ceramic with good interlayer bonding, dense microstructure, and high microhardness of 17.92 GPa was obtained.

Fabrication and properties of alumina ceramics shaped by digital light processing as an additive manufacturing technology

Microstructures and mechanical properties of additively manufactured alumina ceramics with digital light processing

Additive manufacturing of Al2O3 ceramic core with applicable microstructure and mechanical properties via digital light processing of high solid loading slurry

Preparation of high performance dense Al 2 O 3 ceramics by digital light processing 3D printing technology

Polycrystalline alumina ceramic fabrication using digital stereolithographic light process

Influence of resin composition on rheology and polymerization kinetics of alumina ceramic suspensions for digital light processing (DLP) additive manufacturing

High‐Quality Translucent Alumina Ceramic Through Digital Light Processing Stereolithography Method

Fabrication and mechanical properties of triply period minimal surface porous alumina ceramics based on Digital Light Processing 3D printing technology

Fabrication of fine and complex lattice structure Al2O3 ceramic by digital light processing 3D printing technology

Numerical Simulation of Sintering of DLP Printed Alumina Ceramics

Digital light processing‐based additive manufacturing of orientation‐controlled Al2O3 ceramics with improved damage tolerance

Effect of particle size distribution and printing parameters on alumina ceramics prepared by Additive Manufacturing

Additive Manufacturing and Characterization of Complex Al2o3 Parts Based on A Novel Stereolithography Method

Rheological behavior and curing deformation of paste containing 85 wt% Al2O3 ceramic during SLA-3D printing

Study of alumina ceramic parts fabricated via DLP stereolithography using powders with different sizes and morphologies

Effects of debinding condition on microstructure and densification of alumina ceramics shaped with photopolymerization-based additive manufacturing technology

Fabrication and characterisation of ceramics via low-cost DLP 3D printing

Preparation of large-size alumina ceramic parts by DLP 3D printing using high-solid-loading paste and optimizing the debinding process

High-resolution multiceramic additive manufacturing based on digital light processing

Fabrication of alumina ceramics with high flexural strength using stereolithography

Preparation and properties of Si3N4 ceramics via digital light processing using Si3N4 powder coated with Al2O3-Y2O3 sintering additives