Preparation and Characterization of p-Type Copper Gallium Oxide (CuGaO2) Thin Films by Dual Sputtering Using Cu and Ga2O3 Targets

Ashwin Kumar Saikumar,Sreeram Sundaresh,Kalpathy B. Sundaram
DOI: https://doi.org/10.1149/2162-8777/ac7821
IF: 2.2
2022-06-14
ECS Journal of Solid State Science and Technology
Abstract:For the first time, this research focuses on the deposition and characterization of radio frequency (RF) sputtered p-type CuGaO2 thin films using the dual-target sputtering technique with Cu and Ga2O3 targets. The sputtering power to the Cu target was varied from 5W to 50W while having the Ga2O3 sputtering power constant at 200W. The deposited films were subsequently annealed at two different annealing temperatures of 800°C and 900°C in N2 ambiance. The effects of variation in Cu sputtering power and annealing temperature on structural, optical, and electrical properties of CuGaO2 thin films are reported in this work. Single-phase CuGaO2 was confirmed in films deposited with Cu sputtering power of 25W by XRD analysis. XPS analysis revealed a stoichiometric composition ratio of Cu:Ga in films deposited with Cu sputtering power of 25W. The optical studies were performed in 200 nm - 800 nm wavelengths on all the post-deposition annealed films. The optical transmission was found to decrease with increase in Cu sputtering power. The optical bandgap was found to be between 3.3 and 4.6 eV. Single-phase CuGaO2 film was p-type with a resistivity of 60 Ω-cm. This resistivity value is one of the lowest ever reported values identified from CuGaO2 thin films.
materials science, multidisciplinary,physics, applied
What problem does this paper attempt to address?