Abstract:In this work, we propose a simple and efficient interfacial modification method for thin-film transistor (TFT)-1 with poor stability under bias stress. For conventional top-contact TFT-2, the sputtering passivation layer will cause the device to be in a short-circuit condition. We used inverted coplanar-structured TFT-3 to separate the high conductivity layer from the S/D electrodes to avoid the short-circuit failure of the device, but this will cause a hump effect. Ultraviolet treatment and air annealing were performed on TFT-3 simultaneously to obtain TFT-4 with high mobility (μsat = 45.5 cm2 V–1 s–1), steep subthreshold swing (SS = 86 mV/dec), and good bias stability (±20 V, 3600 s, NBS: −0.1 V, PBS: +0.9 V, PGDBS: +0.5 V). The forward and reverse tests of TFT-1 and TFT-4 after the PGDBS test show that TFT-4 has a good stability of the asymmetric electrical bias. Finally, XRR, XPS, AFM, and contact angle were tested to further investigate the material mechanisms. In this paper, we show that the interfacial passivation of TFT can effectively isolate the invasion of external water/oxygen and compensate for interfacial defects and dangling bonds. The decomposition and rearrangement of the oxide are induced by UV + thermal annealing, which optimizes the stacking pattern of the cells, effectively reducing the defect states and eliminating parasitic channels and the hump phenomenon. Finally, an amorphous oxide semiconductor (AOS)-TFT instrument with high mobility and good stability is prepared. The method in this paper addresses the problem that the passivation layer cannot be prepared by sputtering, which is a cost-effective process.

High-performance a-ITZO TFTs with high bias stability enabled by self-aligned passivation using a-GaOx

Positive gate bias instability alleviated by self-passivation effect in amorphous InGaZnO thin-film transistors

Improved Performance and Bias Stability of Al2O3/IZO Thin-Film Transistors with Vertical Diffusion

Negative-U Defect Passivation in Oxide-Semiconductor by Channel Defect Self-Compensation Effect to Achieve Low Bias Stress VTH Instability of Low-Thermal Budget IGZO TFT and FeFETs

Scalability and Stability Enhancement in Self-Aligned Top-Gate Indium- Zinc-Oxide TFTs with Al Reacted Source/Drain

35‐4: High‐Mobility and High‐Negative Bias Illumination Stress Stability Based on ITZO/IGZO Bilayer Thin Film Transistors

Enhanced Bias Stress Stability of A-Ingazno Thin Film Transistors by Inserting an Ultra-Thin Interfacial InGaZnO:N Layer

Stablity research and application of amorphous indium gallium zinc oxide tfts for active matrix organic light-emitting diode display

Improving Reliability of a-InGaZnO TFTs With Optimal Location of Al2O3 Passivation in Moist Environment

Stability and gap states of amorphous In-Ga-Zn-Ox thin film transistors: Impact of sputtering configuration and post-annealing on device performance

Characteristics of amorphous In-Ga-Zn-O thin-film-transistors with channel layer deposited by bias sputtering

Self-Compensation Effect of Photo-Bias Instabilities in a-InGaZnO Thin-Film Transistors Induced by Unique Ion Migration

Mobility and Stability Enhancement of Amorphous In-Ga-Zn-O TFTs with Atomic Layer Deposited Al2O3/SiO2Stacked Insulators

Improved mobility and bias stability of Hf-doped IGZO/IZO/Hf-doped IGZO thin-film transistor

Enhancements of electrical properties and positive bias instability in self-aligned top-gate a-IGZO TFTs by hydrogen incorporation

Temperature Dependent Anomalous Threshold Voltage Modulation of a-IGZO TFT by Incorporating Variant Gate Stresses

High Reliability Of Igzo Tfts Using Low-Temperature Fabricated Organic Passivation Layers

Enhancement of Positive Bias Stress Stability for IGZO TFTs by A CAAC Gd-AZO Bulk Layer

The Hump Phenomenon and Instability of Oxide TFT Were Eliminated by Interfacial Passivation and UV + Thermal Annealing Treatment

P-15: AZO Etch Buffer Layer Based Back-Channel-Etch A-Igzo TFT Technology

High mobility of IGO/IGZO double-channel thin-film transistors by atomic layer deposition