Abstract:Growing high-quality Si films at high rates with thicknesses ranging from the few nm- to μm-range while keeping the material consumption at a minimum is important for a wide range of Si-based technologies, spanning from batteries to sensors and solar cells. In this work, we elucidate the effects of electron beam deposition (e-beam) conditions on the growth of ~4 μm thick Si layers on bare and thermally oxidized (001)-oriented Si substrates. All depositions are performed from a stabilized and refillable melt of broken B-doped wafers and recollected using Si-shields during deposition for recycling. We find that increasing the deposition rate from 0.3 to 23 nm/s at a substrate temperature of 1000 °C reduces the roughness, void fraction, and residual stress of epitaxial Si-on-Si layers. For Si-on-SiO2, all films are polycrystalline under the same deposition conditions as for Si-on-Si, with a reduction in void fraction and increase in roughness at higher deposition rates. The residual stress for Si-on-SiO2 is comparable across all deposition rates >1 nm/s. Furthermore, we measure lower resistivities in the films than in the feedstock for Si-on-Si and higher than the feedstock for Si-on-SiO2. While the films become microstructurally denser and less defective at higher deposition rates, the resistivity increases for each next deposition step in the case of multi-step depositions from the same feedstock. Time-of-flight scanning secondary mass spectroscopy measurements show that the films have a significantly higher B-concentration than the feedstock, suggesting B-gettering to the melted region and transferring to the Si film upon the e-beam deposition process. This work demonstrates how electron beam evaporation can be used to recollect and recycle waste Si pieces, bringing important insights into how the deposition parameters influence the quality of the deposited polycrystalline as well as epitaxial thin-to-thick films.

Silicon epitaxy grown by electron‐beam evaporation in ultrahigh vacuum at 200 °C

Wafer‐scale Single‐crystalline MoSe2 and WSe2 Monolayers Grown by Molecular‐beam Epitaxy at Low‐temperature — the Role of Island‐substrate Interaction and Surface Steps

Growth and Electro-Optical Characteristics of CdSe / GaAs Epilayers Prepared by Electron Beam Epitaxy

300mm Cold-Wall UHV/CVD Reactor for Low-Temperature Epitaxial (100) Silicon

Characterization and growth of germanium-silicon epitaxial layers by UHV/CVD

Low Temperature Silicon Epitaxy in a Single-Wafer RTP Reactor with Microwave Heating

An Ultrahigh Vacuum Chemical Vapor Deposition System and Si, GeSi Epitaxy on a Three-Inch Si Wafer

Growth of 3C–SiC on 150-mm Si(100) substrates by alternating supply epitaxy at 1000°C

High-vacuum Electron-Beam Co-Evaporation of Si Nanocrystals Embedded in Al2O3 Matrix

Doping And Growth Of Thin Si Epilayer And Sige By Uhv/Cvd

Heteroepitaxial Growth of Germanium-on-Silicon Using Ultrahigh-Vacuum Chemical Vapor Deposition with RF Plasma Enhancement

Heat exchanges and columnar growth in electron‐beam evaporation of silicon films for solar cell applications

Rate-Dependent Evolution of Microstructure and Stress in Silicon Films Deposited by Electron Beam Evaporation

Epitaxial growth of atomically thin Ga2Se2 films on c-plane sapphire substrates

Effects of Growth Kinetics and Surface Emissivity on Chemical Vapor Deposition of Silicon in a Lamp-Heated Single-Wafer Reactor

Homoepitaxial Chemical Vapor Deposition of up to 150 μm Thick 4H-SiC Epilayers in a 10×100 mm Batch Reactor

Epitaxially Oriented Growth of Diamond on Silicon by Hot Filament Chemical Vapor Deposition

Epitaxial Ge thin film Growth on Si Using a Cost-Effective Process in Simplified CVD Reactor

Unusual Catalyst-Free Epitaxial Growth Of Silicon Nanowires By Thermal Evaporation

Epitaxy of SiGe Layers by Ultrahigh Vacuum Chemical Vapor Deposition

An Ultrahigh Vacuum Chemical Vapor Deposition System and Its Application to Growth of Nmosfet and Hbt Structures