Abstract:In general, with the addition of solutes, the yield strength of alloys is expected to increase and this phenomenon is known as solid solution strengthening. However, reports on the ``anomalous'' softening with alloying additions are not uncommon; for example, it is known that the heterogeneous nucleation of dislocations at the sites of solute atoms can lead to softening. In this study, using Molecular Dynamics (MD) simulations, we show anomalous softening in Cu-Al alloys deformed at 300 K; specifically, not only the yield stress but also the magnitude of stress drop at yield decrease with increasing Al content. We calculate the stress needed for the homogeneous nucleation of partial dislocation loops using a continuum model. One of the key inputs to the continuum model is the stacking fault energy (SFE). We carry out the thermodynamic integration to evaluate the free energies in crystals with and without the stacking faults and hence calculate the SFE as a function of Al content at 300 K. Using the SFE values thus obtained we show that softening is a consequence of the reduction of SFE values with the addition of Al in a system where yielding is controlled by the nucleation of dislocation loops. Specifically, the results of continuum model are in good agreement with MD simulation results of pure copper. However, in the Cu-Al alloys, the drop in yield strength can only be explained using a combination of the continuum model (which assumes homogeneous nucleation), and the reduction in heterogeneous nucleation barrier (which is a function of the ratio of the unstable and stable stacking fault energies). We show that the decrease in stress drop can be rationalised in terms of the stored energy available at yielding -- the stored energy at yielding decreases with increasing Al, and, as a result, the maximum dislocation density decreases with increasing Al content.

Electron microscopy of a low stacking fault energy alloy

Local Lattice Distortion Mediated Formation of Stacking Faults in Mg Alloys

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Transmission Electron Microscopy Characterization of Dislocation Structure in a Face-Centered Cubic High-Entropy Alloy Al0.1CoCrFeNi

The Role of Stacking Fault Energy of Cu–Al and Cu–Mn Alloys During Their Deformation in Low-Stability States

Atomic scale characterization of complex stacking faults and their configurations in cold deformed Fe42Mn38Co10Cr10 high-entropy alloy

Molecular-dynamics simulations of stacking-fault-induced dislocation annihilation in pre-strained ultrathin single-crystalline copper films

Evolution of Microstructure and its Parameters after Deformation of Polycrystalline Cu-Al Alloys with Different Stacking Fault Energy

Electron Tomography of Dislocations in an Al-Cu-Mg Alloy

Determination of Stacking Fault Probability in Fcc Fe-Mn-Si-Al Alloy by Electron Diffraction

Direct observations of collinear dislocation interaction in a Fe-17.4 Mn-1.50 Al-0.29 C (wt.%) austenitic steel under cyclic loading by in-situ electron channelling contrast imaging and cross-correlation electron backscatter diffraction

An in situ ambient and cryogenic transmission electron microscopy study of the effects of temperature on dislocation behavior in CrCoNi-based high-entropy alloys with low stacking-fault energy

Complex Stacking Fault Energy of Cr-alloyed Γ-Tial

Atomistic Simulation of the Stacking Fault Energy and Grain Shape on Strain Hardening Behaviours of FCC Nanocrystalline Metals

Transmission Electron-Microscopy Study of Small-Angle Grain-Boundaries, Dislocations and Modulated Phases in Al-Li-Cu Quasi-Crystals

Calculations for populations of selected isotopes in intermediate energy heavy ion collisions

Deformation Twinning Behaviors of the Low Stacking Fault Energy High-Entropy Alloy: an In-Situ TEM Study

Stacking fault energy induced softening in the nucleation limited plasticity regime: a molecular dynamics study on Cu-Al alloys

Stacking fault segregation imaging with analytical field ion microscopy

Stacking Fault Tetrahedra in Single-Crystal Aluminum Induced by High-Current Pulsed Electron Beam

Stacking Fault Tetrahedron Induced Plasticity in Copper Single Crystal