Abstract:Face-centered cubic (fcc) high and medium entropy alloys (H/MEAs) have been shown to display superior mechanical properties at low temperatures, but significant improvement of their strength at high temperatures is required for industrial applications at extreme conditions. Recently, it has been shown that the breakthrough of the MEAs from equiatomic/near-equiatomic to non-equiatomic ratios leads to strong MEAs with good ductility. To design new H/MEAs, we consider two important factors that may influence strength: the chemical composition and chemical short range order (CSRO). In this study, we investigate the depinning stress ( σ c ) as a criterion of strength of several compositions of VCoNi concentrated solid solution alloys (CSSAs) including V 0.33 Co 0.33 Ni 0.33 , V 0.35 Co 0.2 Ni 0.45 , V 0.33 Co 0.17 Ni 0.5 , and V 0.17 Co 0.33 Ni 0.5 at 5 K and 300 K, using atomistic simulations. The chosen interatomic potential is shown to be reliable by comparing experimental/ ab initio values and calculated parameters such as lattice constant, shear modulus, depinning stress, and temperature variation of stacking fault width for equimolar VCoNi. We find a good agreement between experimental friction stress and the depinning stress extracted from our results for equimolar VCoNi. Also, we find that Vclusters are the main pinning points of dislocations, and With a random distribution of atoms, we find that the alloy composition V 0.33 Co 0.17 Ni 0.5 displays the largest depinning stress at both 5 and 300 K. Furthermore, to investigate how CSRO affects the strength of these alloys, we design CSRO into the microstructure using two different methods: In the first method, hybrid Molecular-dynamics/Monte-Carlo simulations were employed to simulate annealing at various temperatures. We observe that such simulations create CSRO so that it increases with decreasing annealing temperature. Recently, the CSRO motif and its concentration in an equimolar VCoNi have been determined by experiment. By modeling this experiment, we also implemented the CSRO into microstructure as the second method. By using both methods, the effect of CSRO on the magnitude of the depinning stress is discussed. It was shown that in both methods, CSRO significantly influences the strength of non-equimolar VCoNi alloys.

Defect-induced inhomogeneous atomic environments in complex concentrated alloys

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Compositional Undulation Induced Strain Hardening and Delocalization in Multi-Principal Element Alloys

An in situ ambient and cryogenic transmission electron microscopy study of the effects of temperature on dislocation behavior in CrCoNi-based high-entropy alloys with low stacking-fault energy

The effect of local chemical ordering on dislocation activity in multi-principle element alloys: a three-dimensional discrete dislocation dynamics study

Effect of Strain on the Intrinsic Stacking Fault Energy of Fcc Co: a First-Principles Study

Long-Range Influence of Cr on the Stacking Fault Energy of Cr-Containing Concentrated Solid-Solution Alloys

Computer Simulation on Dislocation Intermittent Motion in the Presence of Solute Atoms

Interactions between screw dislocation and twin boundary in high-entropy alloy: A molecular dynamic study

Atomistic simulations of dislocation plasticity in concentrated VCoNi medium entropy alloys: Effects of lattice distortion and short range order

Multiscale Concurrent Atomistic-Continuum (CAC) modeling of multicomponent alloys

Statistical Modeling of the Effect of Chemical Inhomogeneity on Incipient Plasticity in Complex Concentrated Alloys

Impact of local chemical ordering on deformation mechanisms in single-crystalline CuNiCoFe high-entropy alloys: A molecular dynamics study

Interactions between irradiation-induced defects and dislocations in concentrated solid solution alloys

Interstitial effects on the incipient plasticity and dislocation behavior of a metastable high-entropy alloy: Nanoindentation experiments and statistical modeling

Edge dislocations in multi-component solid solution alloys: Beyond traditional elastic depinning

Atomistic Investigation of Elementary Dislocation Properties Influencing Mechanical Behaviour of $Cr_{15}Fe_{46}Mn_{17}Ni_{22}$ alloy and $Cr_{20}Fe_{70}Ni_{10}$ alloy

Dislocation reaction-based formation mechanism of stacking fault tetrahedra in FCC high-entropy alloy

Structural and chemical disorder enhance point defect diffusion and atomic transport in Ni3Al-based γ′ phase

Simulations of the Interactions Between Dislocations and Solute Atoms in Different Loading Conditions

Sluggish hydrogen diffusion and hydrogen decreasing stacking fault energy in a high-entropy alloy