Abstract:Based on the embedded atom method (EAM) and molecular dynamics (MD) method, the mono-crystalline copper with different defects is investigated through tension and nanoindentation simulation. The single-crystal copper nanowire with surface defects is firstly studied through tension. For validation, the tension simulations for nanowire without defect are carried out under different temperatures and strain rates. The defects on nanowires are then systematically studied in considering different defects orientation distribution. It is found that the Young’s modulus is insensitive of surface defects and centro-plane defects. However, the yield strength and yield point show a significant decrease due to the different defects. Specially, the 〖45〗^° defect in surface and in (200) plane exerts the biggest influence to the yield strength, about 34.20% and 51.45% decrease are observed, respectively. Different defects are observed to serve as a dislocation source and different necking positions of the nanowires during tension are found. During nanoindentation simulation, dislocation is found nucleating below the contact area, but no obvious dislocation is generated around the nano-cavity. Comparing with the perfect substrate during nanoindentation, the substrate with nano-cavities emerged less dislocations, it is supposed that the nano-cavity absorbed part of the indent energy, and less plastic deformation happened in the defected substrate.

Transmission Electron-Microscopy Analysis of Planar and Line Defects in an Al-Li-Cu Icosahedral Quasi-Crystal

Tem Study Of Linear And Planar Defects In Icosahedral Al-Li-Cu

Transmission Electron-Microscopy Study of Small-Angle Grain-Boundaries, Dislocations and Modulated Phases in Al-Li-Cu Quasi-Crystals

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Transmission electron microscopy study of defects in AlLiCu quasicrystals

Defects In The Quasicrystalline Phase Of Al-Li-Cu

Dislocations Observed by Transmission Electron-Microscopy in the Quasi-Crystalline Phase T2 of Al-Li-Cu after Deformation

In Situ Atomistic Observation of Grain Boundary Migration Subjected to Defect Interaction

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Incommensurate Modulated Structure in the Icosahedral Quasicrystalline Phase T2 of an Al-Li-Cu Alloy

Electron microscopy study of scratch-induced surface microstructures in an Al-Cu-Fe icosahedral quasicrystal

Special Planar Defects in the Structural Complex Metallic Alloys of Al-Pd-Mn and Al-Ni-Rh

Scratch-induced surface microstructures on the deformed surface of Al-Cu-Fe icosahedral quasicrystals

High-resolution electron microscopy analysis of structural defects in a (2/1, 5/3)-type approximant of a decagonal quasicrystal of an AI-Pd-Mn alloy

Electron microscopy of a low stacking fault energy alloy

Projective Quasiparticle Interference of a Single Scatterer to Analyze the Electronic Band Structure of ZrSiS

Computer-Simulations Of A Distorted Reciprocal Lattice Of An Al-Li-Cu Single Quasicrystal

Phase-Transformation from Quasi-Crystal to Crystal

Transmission Electron Microscopy Study of the Microstructure and Dislocation Configuration in Al67Co8Ti25

The Investigation Of Impurity Distributions Around An Oval Defect In Molecular-Beam Epitaxy Algaas/Gaas Single Quantum-Wells By Transmission Electron-Microscopy And Cathodoluminescence

Atomic scale analyses of {\bb Z}-module defects in an NiZr alloy