Abstract:Dislocation loops in quenched aluminum alloys are usually seen deviating from their nominal habit planes, while the orientation distribution and deviation mechanism are far from understanding. Based on the method of tomographic crystallography of dislocations and correlative in-situ heating experiments in transmission electron microscopy (TEM), we revisit the three-dimensional (3D) characteristics and deviation behaviors of dislocation loops in a quenched Al-Cu alloy with an aim to fully unravel the relationship between dislocation crystallography and deviation behaviors. The results show that all the dislocation loops exhibit approximately circular shapes and have a/2 < 110>-type Burgers vectors, with loop orientations deviating from their pure edge orientation {110} of 0°-17.8° and distributing mainly close to the [101]-[001] and [101]-[111] edges of the standard stereographic triangle. Three types of deviation behaviors of dislocation loops are then defined, which are characterized by loop rotation around 〈100〉, 〈110〉 and irregular axes, respectively. Theoretical calculations of strain energy variation with increasing deviation angle indicate that the relatively low energy barrier may account for a high frequency of loop deviation in the low angle range. Detailed in-situ TEM heating experiments and correlative tomographic crystallography analyses strongly demonstrate the specific roles of dislocation gliding and climbing at elevated temperatures in the shrinkage, polygonization and deviation processes of dislocation loops, and the competitive and cooperative motion of dislocation segments close to slip planes {111} are the fundamental reasons for the formation of three types of deviated dislocation loops.

Dislocations Observed by Transmission Electron-Microscopy in the Quasi-Crystalline Phase T2 of Al-Li-Cu after Deformation

Transmission Electron-Microscopy Study of Small-Angle Grain-Boundaries, Dislocations and Modulated Phases in Al-Li-Cu Quasi-Crystals

Transmission Electron-Microscopy Analysis of Planar and Line Defects in an Al-Li-Cu Icosahedral Quasi-Crystal

Transmission electron microscopy study of defects in AlLiCu quasicrystals

Electron Tomography of Dislocations in an Al-Cu-Mg Alloy

Transmission Electron Microscopy Observation of a Dislocation Loop in an Al70Co15Ni15decagonal Quasicrystal

Experimental Characterization of Dislocations in Deformation Induced Planar Boundaries of Rolled Aluminium

Arrangement and Decomposition of Grain Boundary Dislocations: Two-Mode Phase-Field Crystal Simulation

Dislocation Mediated Dynamic Tension-Compression Asymmetry of a Ni2CoFeV0.5Mo0.2 Medium Entropy Alloy

Incommensurate Modulated Structure in the Icosahedral Quasicrystalline Phase T2 of an Al-Li-Cu Alloy

Electron Microscopic Study of Partial Dislocations in Textured Y-Ba-Cu-O Superconductors

Tensile Deformation Behavior of Copper Bicrystal with Perpendicular Grain Boundary

On the Determination of Burgers Vectors of Type-B Dislocations in an Al70co15ni15 Decagonal Quasi-Crystal by Convergent-Beam Electron-Diffraction

Dislocation-mediated plasticity in the Al$_{2}$Cu θ-phase

Orientation distribution and deviation behaviors of dislocation loops in a quenched Al-Cu alloy

Tension/compression asymmetry of grain boundaries with non-planar structure

Electron microscopy of a low stacking fault energy alloy

Dislocation-twin boundary interaction in small scale Cu bi-crystals loaded in different crystallographic directions

Birefringence Images of Screw Dislocations Viewed End on in Cubic-Crystals Containing A Long-Range Stress-Field

Atomistic Study of Fundamental Character and Motion of Dislocations in Intermetallic Al2Cu

Dislocation content of geometrically necessary boundaries aligned with slip planes in rolled aluminium