Abstract:<p>We studied the combined and interactive effects of crystallographic orientation, strain amplitude, cycle number, stacking fault energy (SFE) and hydrogen doping on the microstructure evolution of polycrystalline high-manganese steels (HMnSs) under low-cycle fatigue (LCF). An integrated experimental approach combining digital image correlation (DIC), electron backscatter diffraction (EBSD) and electron channelling contrast imaging (ECCI) at interrupted cycles was performed in the same region of interest on the bulk shear samples, which enables us to systematically compare the dislocation patterns of grains with defined loading conditions at a much larger field of view and less artefacts compared to transmission electron microscopy (TEM). We found that Taylor factor (M) works well with describing the effect of crystallographic orientation, which was further proved by the crystal plasticity finite element method (CPFEM). In detail, grains with a medium M value (3.3–3.9) tend to form more complex dislocation pattern, which is defined as sensitive value. Generally, increasing strain amplitude and cycle number both promote the evolution of dislocation pattern while their efficiencies depend strongly on grain orientation. The promotion effect of SFE on dislocation evolution becomes obvious at larger strain amplitudes (>0.4%) and non-sensitive M value. Hydrogen can strongly assist the formation of ε-martensite and reduce its critical resolved shear stress (CRSS), while it retards the evolution of dislocation pattern. The number of activated martensite variants in individual grain can be well predicted by its M value. With increasing strain amplitude, the fraction of ε-martensite increases in a manner of thinner but denser plates.</p>

Direct observations of collinear dislocation interaction in a Fe-17.4 Mn-1.50 Al-0.29 C (wt.%) austenitic steel under cyclic loading by in-situ electron channelling contrast imaging and cross-correlation electron backscatter diffraction

Cracking in a Fe–25Mn–3Si–3Al Steel

Fundamental and experimental aspects of diffraction for characterizing dislocations by electron channeling contrast imaging in scanning electron microscope

Data-mining of in-situ TEM experiments: On the dynamics of dislocations in CoCrFeMnNi alloys

In-situ investigation of the interaction between hydrogen and stacking faults in a bulk austenitic steel

Atomistic and continuum study of interactions between super-screw dislocations and coherent twin boundaries in L 12 -structured Ni 3 AI

In Situ Observation of Austenite–ferrite Interface Migration in a Lean Mn Steel During Cyclic Partial Phase Transformations

The combined and interactive effects of orientation, strain amplitude, cycle number, stacking fault energy and hydrogen doping on microstructure evolution of polycrystalline high-manganese steels under low-cycle fatigue

In situ atomic-scale observation of dislocation climb and grain boundary evolution in nanostructured metal

Strain rate-dependent hardening with dislocation-twin interaction of Fe–Mn–Al–C steel using crystal plasticity

In-situ TEM study of dislocation emission associated with austenite growth

Dynamic mechanisms of strengthening and softening of coherent twin boundary via dislocation pile-up and cross-slip

Atomistic Investigation of Elementary Dislocation Properties Influencing Mechanical Behaviour of $Cr_{15}Fe_{46}Mn_{17}Ni_{22}$ alloy and $Cr_{20}Fe_{70}Ni_{10}$ alloy

Defect-induced inhomogeneous atomic environments in complex concentrated alloys

Atomistic Simulation of Interactions Between an Edge Dislocation and Cu Precipitates with Different Chemical Compositions in Α-Fe

In-situ study on the coordinated deformation mechanism of austenitic stainless steel with mixed crystal degree

Electron microscopy of a low stacking fault energy alloy

Atomistic Simulations for the Evolution of a U-shaped Dislocation in Fcc Al

B12-P-08In Situ Observation of Dislocation Accumulation and Small Angle Grain Boundary Formation

Investigating the dislocation reactions on Σ3{111} twin boundary during deformation twin nucleation process in an ultrafine-grained high-manganese steel

An Extended Near-Coincidence-sites Method and the Interfacial Structure of Austenite Precipitates in a Duplex Stainless Steel