Abstract:The Peierls–Nabarro dislocation model is applied in this paper to investigate the [110] full dislocations on the (001), (111), and (1 ̄10) planes in pure Al, as well as the (110) small-angle tilting grain boundary (SATGB) composed of them. The findings demonstrate that the stress–strain fields of both dislocations and grain boundaries can be accurately described by a five-term single dislocation strain field. The Peierls stresses for the [110] edge-type dislocations on the (001), (111), and (1 ̄10) planes are 67.15 MPa, 114.93 MPa, and 847.56 MPa, respectively, exhibiting an increasing trend in magnitude. As the inter-dislocation distance decreases in the (110) SATGB of Al, the stress field, half-width, decomposition trend, and line energy of individual dislocations gradually decrease. The change in the line energy can be divided into three parts: Initially, there is a slow decrease when the distance is greater than ~200 Å. This is followed by a sharp drop in the line energy as the distance further decreases, with a slowing down of this trend at ~70 Å, where strain energy becomes dominant. In the final stage, the changes in the strained energy and core energy synergistically contribute. The (110) SATGB energy exhibits an increasing trend with the increment of the angle. The Peierls energy and force of the (110) SATGB composed of [110] full dislocations on the Al (001) and (111) surfaces exhibit minimal variation as the distance between dislocations changes, whereas a slight decrease is observed on the (110) surface. The present study provides valuable insights into the investigation of mechanical properties in Al alloys with nanometer-sized grains.

B12-P-08In Situ Observation of Dislocation Accumulation and Small Angle Grain Boundary Formation

In Situ Atomistic Observation of Grain Boundary Migration Subjected to Defect Interaction

Inclination-governed Deformation of Dislocation-Type Grain Boundaries

Microstructural and texture evolution investigation of laser melting deposited TA15 alloy at 500?C using in-situ EBSD tensile test

In SituObservation of Dislocation Behavior in Nanometer Grains

Arrangement and Decomposition of Grain Boundary Dislocations: Two-Mode Phase-Field Crystal Simulation

In situ atomic-scale observation of dislocation climb and grain boundary evolution in nanostructured metal

Resolving localized geometrically necessary dislocation densities in Al-Mg polycrystal via in situ EBSD

In situ observation of dislocations at crack tip insingle crystalline tantalum

Study of Dislocation Boundary Structure in Al–Li Alloy During Bending

First-Principles Study of Physical Properties of (110) Symmetric Small-Angle Tilting Grain Boundary with Full Dislocation in Aluminum

B22-O-12In Situ Atomic Scale Observation of Grain Rotation Mediated by Grain Boundary Dislocations

In-situ Study of the Effect of Strain Path Change on Dislocation Boundary Evolution in Commercial Purity Aluminum

Direct observation of the grain boundaries acting as dislocation sources in nanocrystalline platinum

Molecular dynamics study on the grain boundary dislocation source in nanocrystalline copper under tensile loading

In-situ EBSD Study of the Active Slip Systems and Lattice Rotation Behavior of Surface Grains in Aluminum Alloy During Tensile Deformation

Observing Dislocations Transported by Twin Boundaries in Al Thin Film: Unusual Pathways for Dislocation-Twin Boundary Interactions

Investigation of Grain Subdivision at Very Low Plastic Strains in A Magnesium Alloy

Direct observations of collinear dislocation interaction in a Fe-17.4 Mn-1.50 Al-0.29 C (wt.%) austenitic steel under cyclic loading by in-situ electron channelling contrast imaging and cross-correlation electron backscatter diffraction

Dislocation-twin boundary interaction in small scale Cu bi-crystals loaded in different crystallographic directions

3D microstructural and strain evolution during the early stages of tensile deformation