Abstract:In the current study, dislocation activity and storage during creep deformation in a nickel based superalloy (Waspaloy) were investigated, focussing on the storage of geometrically necessary (GND) and statistically stored (SSD) dislocations. Two methods of GND density calculation were used, namely, EBSD Hough Transformation and HR-EBSD Cross Correlation based methods. The storage of dislocations, including SSDs, was investigated by means of TEM imaging. Here, the concept of GND accumulation in soft and hard grains and the effect of neighbouring grain orientation on total dislocation density was examined. Furthermore, the influence of applied stress (below and above the yield stress of Waspaloy) during creep on deformation micro-mechanism and dislocation density was studied. It was demonstrated that soft grains provided pure shear conditions on at least two octahedral (111) slip systems for easy dislocation movement. This allowed dislocations to reach the grain boundary without significant geometrically necessary dislocation accumulation in the centre of the grain. Hence, the majority of the soft grains appeared to have minimum GND density in the centre of the grain with high GND accumulation in the vicinity of the grain boundaries. However, the values and width of accumulated GND depended on the surrounding grain orientations. Furthermore, it was shown that the hard grains were not favourably oriented for octahedral slip system activation leading to a grain rotation in order to activate any of the available slip systems. Eventually, (i) the hard grain resistance to deformation and (ii) neighbouring grain resistance for the hard grain reorientation caused high GND density on a number of octahedral (111) slip systems. The results also showed that during creep below the yield stress of Waspaloy (500 MPa/700 °C), the GND accumulation was relatively low due to the insufficient macroscopic stress level. However, the regions near grain boundaries showed high GND density. At 800 MPa/700 °C (above yield at this temperature), in addition to the movement of pre-existing dislocations (SSD and GND) at a higher mobility rate, large numbers of dislocations were generated and moved toward the grain boundaries. This resulted in a much higher GND density but narrower width of high intensity GNDs near the grain boundaries. It is concluded that although GND measurement by means of EBSD can provide great insight into dislocation accumulation and its behaviour, it is critical to consider SSD type which also contributes to the strain hardening of the material.

Resolving localized geometrically necessary dislocation densities in Al-Mg polycrystal via in situ EBSD

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Inclination-governed Deformation of Dislocation-Type Grain Boundaries

Quantifying Geometrically Necessary Dislocation Density During Hot Deformation in AA6082 Al Alloy

The Grain Size and Orientation Dependence of Geometrically Necessary Dislocations in Polycrystalline Aluminum During Monotonic Deformation: Relationship to Mechanical Behavior

Correlation Between Dislocation Hardening and the Geometrically-Necessary-dislocation Densities in a Hexagonal-Close-packed Zr-2wt%Ti Alloy

Resolving crystallographic geometrically necessary dislocations in three dimensions in a hexagonal close packed titanium alloy

Character and Distribution of Geometrically Necessary Dislocations in Polycrystalline Tantalum

Precise Measurement of Strain Accommodation in a Mg-Gd-Y-Zn Alloy Using Cross-Correlation-based High Resolution EBSD

The dislocation behaviour and GND development in a nickel based superalloy during creep

Intergranular fracture, grain-boundary structure, and dislocation-density interactions in FCC bicrystals

Investigation of Grain Subdivision at Very Low Plastic Strains in A Magnesium Alloy

Consistent determination of geometrically necessary dislocation density from simulations and experiments

Geometrically necessary dislocations and related kinematic hardening in gradient grained materials: A nonlocal crystal plasticity study

Study of the Dislocation Activity in a Mg–Y Alloy by Differential Aperture X-ray Microscopy

Experimental investigation of dislocation-grain boundary interaction in coarse-grained high-manganese steels using quasi in situ electron channelling contrast imaging

Atomic Resolution Analyses on Defects in Nanocrystalline Cu-based Alloys Generated by Severe Plastic Deformation

Dislocation content of geometrically necessary boundaries aligned with slip planes in rolled aluminium

Effect of deformation heterogeneity on development of geometrically necessary dislocation density in heterogeneous-structured CrMnFeCoNi high-entropy alloy

Multiscale discrete dislocation dynamics study of gradient nano-grained materials

3D in-situ characterization of dislocation density in nickel-titanium shape memory alloys using high-energy diffraction microscopy