Abstract:Atomistic simulation methods are appropriate tools for investigating the dynamics of dislocations and their interactions with obstacles in metallic materials. In particular, molecular dynamics (MD) simulations have been widely employed on these two topics in the past several decades. However, even for the same type of simulation, the results can vary. While some of the quantitative differences may be due to the choices of interatomic potential and simulation cell size, they could similarly be attributed to choice of model settings, which have also differed substantially to date. In this paper, we carry out systematic MD simulations to study the effects of a few key model settings on the dynamics of an edge dislocation and its interaction with a void in copper. For a fixed interatomic potential, three modeling parameters, including applied loading mode, boundary conditions, and thermostat, are considered and their influences on the stress-strain response, the dislocation velocity, and the critical stress for a dislocation to bypass a void are compared. For a few select cases, we further examine the influence of temperature, strain rate, and simulation cell size. The results show that (i) compared with flexible boundary conditions, rigid boundary conditions result in greater stress oscillations in simulation cells of certain sizes; (ii) compared with the cases of no thermostat and a full thermostat, a partial thermostat provides better temperature control and lower friction on the dislocation core, respectively; and (iii) for dislocation-void interactions, the critical dislocation bypassing stress in shear loading can be appropriately determined with either a constant applied strain rate or a constant applied stress although the strain rate cannot be controlled in the latter. This analysis reveals that these three settings greatly influence the accuracy and interpretation of the results for the same type of simulation.

Atomistic Simulation of Interactions Between an Edge Dislocation and Cu Precipitates with Different Chemical Compositions in Α-Fe

Atomistic Simulation of Cu–Ni Precipitates Hardening Inα-Iron

The Interaction Mechanisms Between Dislocations and Nano-Precipitates in CuFe Alloys: a Molecular Dynamic Simulation

Deformation of Fe and Ag Precipitates in Cu Matrix

The Contribution of Cu Precipitates to Hardening in α-Fe Matrix

Atomistic Simulation of the Interaction between the Σ9[110](221) Shear-Coupled Grain Boundary Motion and the Cu-rich Precipitates in α-Iron

Discrete dislocation dynamics simulations of dislocation-$θ'$ precipitate interaction in Al-Cu alloys

Dislocations Interaction Induced Structural Instability in Intermetallic Al2Cu

Atomistic study on effects of solute atoms on energy profile of edge dislocation mobility in FCC-Cu alloys

Interaction mechanism of an edge dislocation with a void in Fe–Ni–Cr concentrated solid-solution alloy

Kinetic Effect on the Interaction Between Edge Dislocations and Stacking Fault Tetrahedra in FCC Crystals

Atomistic Simulations of Dislocation Behaviors in Cr-Mn-Fe-Co-Ni High-Entropy Alloys with Different Cr/Ni Ratio

Softening Effects Due to Reorientations of Cu Precipitates in Α-Iron: Atomistic Simulations of Dislocations-Obstacles Interactions

Molecular Dynamics Simulation of Dislocation-γ-Precipitate Interactions in γ’-Precipitates

Atomic Scale Insights into the Rapid Crystallization and Precipitation Behaviors in FeCu Binary Alloys

Atomistic Simulations for the Evolution of a U-shaped Dislocation in Fcc Al

Atomistic Simulations of Dynamics of an Edge Dislocation and Its Interaction with a Void in Copper: a Comparative Study

An atomistic investigation of the interaction of dislocations with Guinier-Preston zones in Al-Cu alloys

Anisotropy effect on the motion of edge dislocation in body-centered-cubic Fe

Mechanical Properties and Dislocation Evolution of Cu–Fe Interfaces from Molecular Dynamics Simulation

Atomistic and continuum study of interactions between super-screw dislocations and coherent twin boundaries in L 12 -structured Ni 3 AI