Abstract:In this dissertation, the relationships between structure-mechanical properties-deformation mechanisms in face-centered cubic (FCC) and body-centered cubic (BCC) metallic nanowires have been studied using in situ TEM nanomechanical testing. It is well known that smaller is stronger and the widely-observed size effect is believed to arise from dislocation interactions inside nanocrystals. However, the interaction mechanisms in small-volume nanocrystals remain unexplored. Here, it was found that surface-nucleated dislocations can strongly interact inside the confined volume of Au nanowires, which led to a new type of dislocation-originated stacking fault tetrahedra (SFT), at variance to the widely-believed vacancy-originated SFT. The atomic-scale processes of nucleation, migration and annihilation of dislocation-originated SFT were revealed, shedding new light onto the strain hardening and size effect in small-volume materials. Although nanoscale twinning is an effective mean to enhance the strength of metals, twin-size effect on the deformation and failure of nanotwinned metals remains largely unexplored, especially at the minimum twin size. Here, a new type of size effect in nanotwinned Au nanowires is presented. As twin size reaches the angstrom-scale, Au nanowires exhibit a remarkable ductile-to-brittle transition that is governed by the heterogeneous-to-homogeneous dislocation nucleation transition. Quantitative measurements show that approaching such a nanotwin size limit gives rise to the ultra-high strength in Au nanowires, close to the ideal strength limit of perfect Au. Twinning is a fundamental deformation mode that competes against dislocation slip in crystals. At the nanoscale, higher stresses are required for plastic deformation than that in bulk, which favors twinning over dislocation slip. Indeed, deformation twinning has been well-documented in FCC nanocrystals. However, it remains unexplored in BCC nanostructures. Here, it shows that twinning is the dominant deformation mode in BCC-tungsten nanocrystals. A competition between twinning and dislocation slip occurs when changing the loading orientations, attributed to the defect growth controlled plasticity in BCC nanocrystals. Several important commonalities and differences in FCC and BCC nanocrystals deforming at nanoscale are further proposed. The results from this dissertation advance fundamental understanding of plastic deformation in a broad class of metals and alloys, and are of technological importance for degradation control and future design of ultra-strength nanomaterials.

Anisotropy effect on the motion of edge dislocation in body-centered-cubic Fe

Discrete Twinning Dynamics and Size-Dependent Dislocation-to Twin Transition in Body-Centred Cubic Tungsten

Bending-induced Deformation Twinning in Body-Centered Cubic Tungsten Nanowires

In Situ TEM Study on the Nanomechanical Behaviors of Metallic Nanowires

Unstable Twin In Body-Centered Cubic Tungsten Nanocrystals

Atomistic Simulation of Interactions Between an Edge Dislocation and Cu Precipitates with Different Chemical Compositions in Α-Fe

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Atomistic study on effects of solute atoms on energy profile of edge dislocation mobility in FCC-Cu alloys

Anisotropy in homogeneous dislocation nucleation by nanoindentation of single crystal Cu

Composition influence on edge dislocation mobility in an FCC high-entropy alloy

The kink-pair nucleation in edge dislocation motion

Dynamic mechanisms of strengthening and softening of coherent twin boundary via dislocation pile-up and cross-slip

Deformation behaviour of body centered cubic Fe nanowires under tensile and compressive loading

Defect-induced inhomogeneous atomic environments in complex concentrated alloys

Discrete Shear Band Plasticity Through Dislocation Activities in Body-Centered Cubic Tungsten Nanowires

Investigation of Structure and Energy of Edge Dislocation in Bcc Iron

Electronic structures of the 〈100〉{010}, 〈100〉{011} and 1/2〈111〉{011} edge dislocations in bcc iron

Anisotropy in interface stress at the BCC-iron solid-melt interface: molecular dynamics and phase field crystal modelling

Twinning induced by elastic anisotropy in FCC crystals

Formation Mechanism of Stress-Induced Anisotropy in Stress-Annealed Fe-based Nanocrystalline Ribbon Alloys