Abstract:Face-centered cubic (fcc) high and medium entropy alloys (H/MEAs) have been shown to display superior mechanical properties at low temperatures, but significant improvement of their strength at high temperatures is required for industrial applications at extreme conditions. Recently, it has been shown that the breakthrough of the MEAs from equiatomic/near-equiatomic to non-equiatomic ratios leads to strong MEAs with good ductility. To design new H/MEAs, we consider two important factors that may influence strength: the chemical composition and chemical short range order (CSRO). In this study, we investigate the depinning stress ( σ c ) as a criterion of strength of several compositions of VCoNi concentrated solid solution alloys (CSSAs) including V 0.33 Co 0.33 Ni 0.33 , V 0.35 Co 0.2 Ni 0.45 , V 0.33 Co 0.17 Ni 0.5 , and V 0.17 Co 0.33 Ni 0.5 at 5 K and 300 K, using atomistic simulations. The chosen interatomic potential is shown to be reliable by comparing experimental/ ab initio values and calculated parameters such as lattice constant, shear modulus, depinning stress, and temperature variation of stacking fault width for equimolar VCoNi. We find a good agreement between experimental friction stress and the depinning stress extracted from our results for equimolar VCoNi. Also, we find that Vclusters are the main pinning points of dislocations, and With a random distribution of atoms, we find that the alloy composition V 0.33 Co 0.17 Ni 0.5 displays the largest depinning stress at both 5 and 300 K. Furthermore, to investigate how CSRO affects the strength of these alloys, we design CSRO into the microstructure using two different methods: In the first method, hybrid Molecular-dynamics/Monte-Carlo simulations were employed to simulate annealing at various temperatures. We observe that such simulations create CSRO so that it increases with decreasing annealing temperature. Recently, the CSRO motif and its concentration in an equimolar VCoNi have been determined by experiment. By modeling this experiment, we also implemented the CSRO into microstructure as the second method. By using both methods, the effect of CSRO on the magnitude of the depinning stress is discussed. It was shown that in both methods, CSRO significantly influences the strength of non-equimolar VCoNi alloys.

Composition influence on edge dislocation mobility in an FCC high-entropy alloy

Unusual Dislocation Behavior in High-Entropy Alloys

Atomistic Simulations of Dislocation Behaviors in Cr-Mn-Fe-Co-Ni High-Entropy Alloys with Different Cr/Ni Ratio

Molecular dynamics study on the dislocation evolution mechanism of temperature effect in nano indentation of FeCoCrCuNi high-entropy alloy

Edge dislocations in multi-component solid solution alloys: Beyond traditional elastic depinning

An in situ ambient and cryogenic transmission electron microscopy study of the effects of temperature on dislocation behavior in CrCoNi-based high-entropy alloys with low stacking-fault energy

Temperature and composition dependent screw dislocation mobility in austenitic stainless steels from large-scale molecular dynamics

Anisotropy effect on the motion of edge dislocation in body-centered-cubic Fe

Atomistic Simulation of Interactions Between an Edge Dislocation and Cu Precipitates with Different Chemical Compositions in Α-Fe

THE INFLUENCE OF CHEMICAL COMPOSITION ON SOLID SOLUTION AND STRAIN HARDENING OF SINGLE CRYSTALS OF FCC HIGH-ENTROPY ALLOYS

Atomistic study on effects of solute atoms on energy profile of edge dislocation mobility in FCC-Cu alloys

Anomalous dislocation response to deformation strain in CrFeCoNiPd high-entropy alloys with nanoscale chemical fluctuations

Impact of local chemical ordering on deformation mechanisms in single-crystalline CuNiCoFe high-entropy alloys: A molecular dynamics study

Core Structure and Mobility of Edge Dislocations in Face-Centered-cubic Chemically Complex NiCoFe and NiCoFeCu Equiatomic Solid-Solution Alloys

Atomistic Investigation of Elementary Dislocation Properties Influencing Mechanical Behaviour of $Cr_{15}Fe_{46}Mn_{17}Ni_{22}$ alloy and $Cr_{20}Fe_{70}Ni_{10}$ alloy

Effects of Alloying on Deformation Twinning in High Entropy Alloys

Temperature and Crystalline Orientation-Dependent Plastic Deformation of FeNiCrCoMn High-Entropy Alloy by Molecular Dynamics Simulation

The Effect of Cu and Mn Elements on the Mechanical Properties of Single-Crystal CoCrFeNi-based High-Entropy Alloy under Nanoindentation

A molecular dynamics investigation into deformation mechanism of nanotwinned Cu/high entropy alloy FeCoCrNi nanolaminates

Atomistic simulations of dislocation plasticity in concentrated VCoNi medium entropy alloys: Effects of lattice distortion and short range order

Ab-initio study of the structural, elastic and dislocation properties of body-centered cubic refractory HfNbTaTiZr high entropy alloy