Abstract:In general, with the addition of solutes, the yield strength of alloys is expected to increase and this phenomenon is known as solid solution strengthening. However, reports on the ``anomalous'' softening with alloying additions are not uncommon; for example, it is known that the heterogeneous nucleation of dislocations at the sites of solute atoms can lead to softening. In this study, using Molecular Dynamics (MD) simulations, we show anomalous softening in Cu-Al alloys deformed at 300 K; specifically, not only the yield stress but also the magnitude of stress drop at yield decrease with increasing Al content. We calculate the stress needed for the homogeneous nucleation of partial dislocation loops using a continuum model. One of the key inputs to the continuum model is the stacking fault energy (SFE). We carry out the thermodynamic integration to evaluate the free energies in crystals with and without the stacking faults and hence calculate the SFE as a function of Al content at 300 K. Using the SFE values thus obtained we show that softening is a consequence of the reduction of SFE values with the addition of Al in a system where yielding is controlled by the nucleation of dislocation loops. Specifically, the results of continuum model are in good agreement with MD simulation results of pure copper. However, in the Cu-Al alloys, the drop in yield strength can only be explained using a combination of the continuum model (which assumes homogeneous nucleation), and the reduction in heterogeneous nucleation barrier (which is a function of the ratio of the unstable and stable stacking fault energies). We show that the decrease in stress drop can be rationalised in terms of the stored energy available at yielding -- the stored energy at yielding decreases with increasing Al, and, as a result, the maximum dislocation density decreases with increasing Al content.

Evolution of Microstructure and its Parameters after Deformation of Polycrystalline Cu-Al Alloys with Different Stacking Fault Energy

Regularities of Crack Development in Substructures of Cu–Al Alloys Near the Cracking Stability Threshold

An in situ ambient and cryogenic transmission electron microscopy study of the effects of temperature on dislocation behavior in CrCoNi-based high-entropy alloys with low stacking-fault energy

Strain hardening behavior and microstructure evolution of gradient-structured Cu-Al alloys with low stack fault energy

Electron microscopy of a low stacking fault energy alloy

Effect of stacking fault energy on nucleation limited plasticity in Cu-Al alloys

Effect of Stacking Fault Energy on the Grain Structure Evolution of FCC Metals During Friction Stir Welding

Fatigue Behaviors and Dislocation Evolution of Copper and Aluminum Alloy

Plastic deformation of FCC alloys at cryogenic temperature: the effect of stacking-fault energy on microstructure and tensile behaviour

Alloying effects on deformation induced microstructure evolution in copper

Influence of stacking fault energy on twin spacing of Cu and Cu–Al alloys

Ductility Sensitivity to Stacking Fault Energy and Grain Size in Cu–Al Alloys

Influence of stacking fault energy on defect structures and microhardness of Cu and Cu alloys

Effects of SMAT Temperature and Stacking Fault Energy on the Mechanical Properties and Microstructure Evolution of Cu-Al-Zn Alloys

Copper effects on the microstructures and deformation mechanisms of CoCrFeNi high entropy alloys

Stacking fault energy induced softening in the nucleation limited plasticity regime: a molecular dynamics study on Cu-Al alloys

X-ray Diffraction Study of Deformational Evolution of Stacking Faults in Nanocrystalline Metals

Deformation stacking fault probability and dislocation microstructure of cold worked Cu–Sn–5Zn alloys by x-ray diffraction line profile analysis

Collapse of stacking fault tetrahedron and dislocation evolution in copper under shock compression

Effects of stacking fault energy on deformation induced grain boundary relaxation in nanograined Cu alloys

Deformation Twins and Stacking Faults in an AA5182 Al-Mg Alloy Processed by High Pressure Torsion