Abstract:In general, with the addition of solutes, the yield strength of alloys is expected to increase and this phenomenon is known as solid solution strengthening. However, reports on the ``anomalous'' softening with alloying additions are not uncommon; for example, it is known that the heterogeneous nucleation of dislocations at the sites of solute atoms can lead to softening. In this study, using Molecular Dynamics (MD) simulations, we show anomalous softening in Cu-Al alloys deformed at 300 K; specifically, not only the yield stress but also the magnitude of stress drop at yield decrease with increasing Al content. We calculate the stress needed for the homogeneous nucleation of partial dislocation loops using a continuum model. One of the key inputs to the continuum model is the stacking fault energy (SFE). We carry out the thermodynamic integration to evaluate the free energies in crystals with and without the stacking faults and hence calculate the SFE as a function of Al content at 300 K. Using the SFE values thus obtained we show that softening is a consequence of the reduction of SFE values with the addition of Al in a system where yielding is controlled by the nucleation of dislocation loops. Specifically, the results of continuum model are in good agreement with MD simulation results of pure copper. However, in the Cu-Al alloys, the drop in yield strength can only be explained using a combination of the continuum model (which assumes homogeneous nucleation), and the reduction in heterogeneous nucleation barrier (which is a function of the ratio of the unstable and stable stacking fault energies). We show that the decrease in stress drop can be rationalised in terms of the stored energy available at yielding -- the stored energy at yielding decreases with increasing Al, and, as a result, the maximum dislocation density decreases with increasing Al content.

Influence of stacking fault energy on twin spacing of Cu and Cu–Al alloys

Influence of stacking fault energy on defect structures and microhardness of Cu and Cu alloys

Effect of stacking fault energy on nucleation limited plasticity in Cu-Al alloys

Effect of twin spacing on the mechanical behavior and deformation mechanism of nanotwinned Al

Correlation of stacking fault energy with deformation mechanism in Cu–(2, 20)Zn alloys

Evolution of Microstructure and its Parameters after Deformation of Polycrystalline Cu-Al Alloys with Different Stacking Fault Energy

Correlation of Grain Size, Stacking Fault Energy, and Texture in Cu-Al Alloys Deformed under Simulated Rolling Conditions

Ductility Sensitivity to Stacking Fault Energy and Grain Size in Cu–Al Alloys

Generalized stacking fault energies of alloys

Effects of SMAT Temperature and Stacking Fault Energy on the Mechanical Properties and Microstructure Evolution of Cu-Al-Zn Alloys

Influence of stacking fault energy on friction of nanotwinned metals

Stacking fault energy induced softening in the nucleation limited plasticity regime: a molecular dynamics study on Cu-Al alloys

Generalized Stacking Fault Energy of Al-Doped CrMnFeCoNi High-Entropy Alloy

Effect of stacking fault energy on deformation mechanisms in Cu and Cu-30% Zn alloy with gradient structure obtained by SMAT

Effect of Stacking Fault Energy on the Grain Structure Evolution of FCC Metals During Friction Stir Welding

Deformation Twins and Stacking Faults in an AA5182 Al-Mg Alloy Processed by High Pressure Torsion

Size dependency in stacking fault-mediated ultrahard high-entropy alloy thin films

Twin-boundary and Stacking-Fault Energies in Al and Pd.

Local Lattice Distortion Mediated Formation of Stacking Faults in Mg Alloys

Strain hardening behavior and microstructure evolution of gradient-structured Cu-Al alloys with low stack fault energy

Molecular-dynamics simulations of stacking-fault-induced dislocation annihilation in pre-strained ultrathin single-crystalline copper films