Abstract:The extreme sharpness for superhard micro mills is urgently needed to improve the surface quality, restrain size effect and suppress burr formation for the widely used miniature components. Therefore, laser cutting and precision grinding are coupled to form a hybrid method for the fabrication of diamond micro mills with extremely sharp edge. Firstly, the laser cutting simulation of polycrystalline diamond (PCD) based on various laser energy density and laser scanning speed was conducted to provide temperature distribution. Then the laser cutting experiments were conducted, and the influence of laser cutting parameters applied on the machining consequences (kerf width, cutting cycles, affected layer thickness, and surface roughness of cutting section) were analysed according to the simulation model. On this basis, the laser energy density and scanning speed were optimized as 175 J/cm 2 and 0.2 mm/s respectively to obtain the smooth and uniformly graphitized surface. Moreover, the grinding experiments were conducted on the cutting section obtained by the optimized laser parameters, the impact of the abrasive grain size, grinding depth per path and feeding speed on the grinding results were studied, these grinding parameters were optimized as 1 μm, 1 μm, and 2 mm/min to realise the micro abrasion during grinding process. In this way, PCD micro end mills (PCDMs) with surface roughness Sa of 57.3 nm, effective length of 600 μm, diameter of 400 μm, and radius of cutting edge of 0.19 μm were fabricated. Finally, the micro-milling experiments with PCDMs were performed on the Ti-6Al-4V material, the micro slots and thin-walled structure were processed with almost no burrs being observed and the obtained surface roughness Sa of 18.3 nm. With the obtained machining results, the remarkable cutting performance of PCDM was validated.

Nanosecond-Fiber Laser Cutting and Finishing Process for Manufacturing Polycrystalline Diamond-Cutting Tool Blanks

Fabrication of PCD Skiving Cutter by UV Nanosecond Laser

Laser Processing of Coarse Grain Polycrystalline Diamond (PCD) Cutting Tool Inserts using Picosecond Laser Pulses

The fabrication of polycrystalline diamond micro drill based on ultrashort pulsed laser

Cryogenic assisted femtosecond laser ablation of polycrystalline diamond

Fabrication of polycrystalline diamond micro-milling cutter with different grain sizes by picosecond laser

Controllable Diamond Cutting of Structured Surfaces with Subnanometric Height Features on Silicon

Study On Micromachining Of Polycrystalline Diamond By Uv Nanosecond Laser

Ablation Threshold Measurement and Chemical Modification of UV Nanosecond Laser Micromachining of Polycrystalline Diamond

Precision Machining of Single Crystal Diamond Cutting Tool Via Picosecond Laser Irradiation

Nanotwinned diamond cutting tool processed by femtosecond pulsed laser milling with trochoidal trajectory

Ultrashort Pulsed Laser Micromachining of Polycrystalline Diamond

Technological study on laser cutting of polycrystalline diamond compact

Analysis of the machining performance and surface integrity in laser milling of polycrystalline diamonds

Ultra-short pulsed laser processing of single crystalline diamonds for tooling applications

EXPERIMENTAL INVESTIGATION OF THE SURFACE TOPOGRAPHY IN TERMS OF PROCESS PARAMETERS DURING PICOSECOND LASER MACHINING OF POLYCRYSTALLINE DIAMOND

Micro-channels Machining on Polycrystalline Diamond by Nanosecond Laser

Electric Discharge Milling of Polycrystalline Diamond

A STUDY OF FEMTOSECOND LASER POLISHING OF CVD NANOPOLYCRYSTALLINE DIAMOND FILMS

Formation mechanism and controlling technique for fabrication of extremely sharp diamond micro mills

Experiment of WEDM Precision Machining for Polycrystalline Diamond Compact