Abstract:At present, there are several kinds of broadband antireflection coatings (ARCs). For the flat multilayer ARC, it usually contains double, triple, or up to 4 layers. It has been demonstrated that the performance of a single layer coating is not good enough across the desired spectral range. Multiple layer ARCs have much better performance for broadband solar cells (SCs). When inspecting the antireflection structure of Cu2ZnSnS4 solar cells (CZTSSCs), it is shown that the transparent conductive oxide (TCO) of traditional CZTSSCs does not have an satisfactory antireflective performance. This paper aims to investigate a way to increase the incident light transmitted into CZTSSCs, and thus improving the efficiency of solar cells by studying the use of the antireflective effect of a TCO film. It introduces a new type of TCO film with better antireflective properties across a wide wavelength range. An SiO2/ZnO antireflective TCO (ATCO) is designed under AM1.5 illumination. In order to measure the antireflective effect over the 300–800 nm wavelength range, an effective average reflectance method (EAR) is introduced. Considering the effect of the refractive index dispersion and the coupling of the TCO or ATCO films with the active layer, in this paper we use a multi-dimensional transfer matrix to optimize the thickness of each key layer to accurately confirm the best antireflective effect. In addition, the optimized TCO film and the optimized ATCO film in CZTSSCs are compared and analyzed by means of EAR. The result shows, through the comparison of the antireflection between conventional TCO CZTSSCs and ATCO CZTSSCs, that there are considerable differences in final optimal reflectivity between TCO layer and ATCO film. For the conventional CZTSSC, the optimal effective average reflectance of TCO layer is 5.6%, and the lowest reflectivity in the waveband from 400 nm to 500 nm is 6.9%. In addition, the corresponding values obtained in the new ATCO CZTSSC are 3.8% and 1.6% respectively. These apparent changes in reflectivity are appealing in that the new ATCO films can effectively reduce light loss and improve the efficiency of photovoltaic conversion.

Effective utilization of light by transparent conducting oxide layer to enhance the performance of the silicon heterojunction solar cells

Highly Efficient Silicon Heterojunction Solar Cells with ZnO:Al Transparent Electrode and Transition Metal Doped Indium Oxide Interfacial Layer

A Facile Interface Engineering Method to Improve the Performance of FTO/ZnO/CsPbI 3− X Br X ( X < 1)/C Solar Cells

Application of Indium Tin Oxide/Aluminum-Doped Zinc Oxide Transparent Conductive Oxide Stack Films in Silicon Heterojunction Solar Cells

ZnO‐doped In2O3 front transparent contact enables >24.0% silicon heterojunction solar cells

Improved electrical contact properties in Indium-free silicon heterojunction solar cells with amorphous SnO 2 TCO layers

Simulation of a high-efficiency silicon-based heterojunction solar cell

Efficiency Enhancement of c-Si/TiO$_2$ Heterojunction Thin Film Solar Cell Using Hybrid Metal-Dielectric Nanostructures

Modulation of the TCO/MoO x Front Contact Enables >21% High-Efficiency Dopant-Free Silicon Solar Cells

A Brief Review of Transparent Conducting Oxides (TCO): The Influence of Different Deposition Techniques on the Efficiency of Solar Cells

Status and Perspectives of Transparent Conductive Oxide Films for Silicon Heterojunction Solar Cells

Crystalline Silicon Heterojunction Solar Cells with Metal Oxide Window Layers

Enhancing performance of heterojunction silicon solar cells through atomic-layer-deposited MoO x hole contact and atomic-layer-deposited AlZnO layer

Thickness Optimization of Front and Recombination ITO in Monolithic Perovskite/Silicon Tandem Solar Cells

Amorphous SnO2 as Earth‐abundant Stable Transparent Conductive Oxide and Its Application to Si Heterojunction Solar Cells

Photonic-structured TCO front contacts yielding optical and electrically enhanced thin-film solar cells

Influence of Deposition Parameters of ITO Films on the Performance of HJT Solar Cells

Using phosphorus doped hydrogenated silicon oxycarbide film as a window layer on the light entrance side of silicon heterojunction solar cells: The role of phase separation on electron transport

Low‐Cost Tin Oxide Transparent Conductive Films for Silicon Heterojunction Solar Cells

Transparent Conductive Oxide Film with Antireflective Properties for Cu<sub>2</sub>ZnSnS<sub>4</sub> Solar Cells

Power conversion efficiency of 25.26% for silicon heterojunction solar cell with transition metal element doped indium oxide transparent conductive film as front electrode