Abstract:ITO was prepared by mixing gradient In2O3 and SnO2 powders using solid-phase reaction manner. Using electron beam gun tool, ITO films with varied thicknesses were fabricated. The structures and electrical and optical parameters of the prepared films were studied. XRD patterns were used to establish the micro-structural parameters (lattice strain and crystallite size). The SEM shows improvement of grain size with the increase of the film thickness. The electrical parameters of ITO films were measured by means of the standard four-point probe method. It was found that when the film thickness increases from 75 to 375 nm, the resistivity decreases to lower value of 1.65 × 10–4 Ω cm and slightly increases to 1.93 × 10–4 Ω cm at thickness of 375 nm. The ITO films with lower electrical properties are appropriate for high-efficiency CdTe solar cells. In terms of spectral ellipsometry, three optical layer models (adhesive layer of the substrate/B-spline layer of ITO film/surface roughness layer) were applied to estimate the film thickness with high accuracy. The absorption coefficient and energy gap were calculated from the transmission and reflection spectra in the strong absorption region. As the film thickness increases, the optical energy gap was found to increase from 3.56 to 3.69 eV. In terms of Hall effect measurements, both carrier concentration and hall mobility were determined. In addition, influences of ITO layers with various thicknesses on the performance of CdS/CdTe solar cells were checked. When the ITO window layer thickness is 325 nm, Jsc = 17 mA/cm2, Voc = 0.82 V, and FF = 57.4%, the calculated highest power conversion efficiency (PCE) is 8.6%.

Influence of Deposition Parameters of ITO Films on the Performance of HJT Solar Cells

Influence of H2 and O2 Introduction During Sputtering on In2O3-based Transparent Conductive Films and HJT Solar Cells with Copper Electrode

Deposition and Property Characterization of Indium-Tin Oxide Films for Solar Cells Fabrication

Effect of Different Thermo-Treatment at Relatively Low Temperatures on the Properties of Indium‑tin-Oxide Thin Films

Effect of Deposition Conditions on the Properties of TCO Films

Influence of oxygen on sputtered ITiO thin films and their application in silicon heterojunction solar cells

Effect of Oxygen and Hydrogen Flow Ratio on Indium Tin Oxide Films in Rear-Junction Silicon Heterojunction Solar Cells

Influence of Oxygen on Sputtered Titanium‐Doped Indium Oxide Thin Films and Their Application in Silicon Heterojunction Solar Cells

Characterization of Transparent Conductive Oxide Films and Their Effect on Amorphous/crystalline Silicon Heterojunction Solar Cells

Study of hydrogen influence and conduction mechanism of amorphous indium tin oxide for heterojunction silicon wafer solar cells

RF magnetron sputtered indium tin oxide thin films for application in solar cells

High-performance Ti and W co-doped indium oxide films for silicon heterojunction solar cells prepared by reactive plasma deposition

Photoelectric Properties of Ito Thin Films Deposited by Dc Magnetron Sputtering

Preparation of Indium Tin Oxide Thin Films Without External Heating for Application in Solar Cells

In-Sn Oxide Bilayer Transparent Conductive Film by DC Magnetron Sputtering for Silicon Heterojunction Solar Cells

Highly Transparent and Conductive Indium Tin Oxide Thin Films for Solar Cells Grown by Reactive Thermal Evaporation at Low Temperature

Effect of Annealing in ITO Film Prepared at Various Argon-and-Oxygen-Mixture Ratios via Facing-Target Sputtering for Transparent Electrode of Perovskite Solar Cells

Structural, electrical, and optical properties of ITO thin films and their influence on performance of CdS/CdTe thin-film solar cells

Structure, Electrical and Optical Properties of ITO Thin Films and Their influence on Performance of CdS/CdTe Thin-Film Solar Cells

Preparation and Properties of Indium Tin Oxide Films Deposited by Reactive Evaporation at Different Deposited Rate

Investigation of In2O3:SnO2 films with different doping ratio and application as transparent conducting electrode in silicon heterojunction solar cell