Abstract:Microfabrication technology with quartz crystals is gaining importance as the miniaturization of quartz MEMS devices is essential to ensure the development of portable and wearable electronics. However, until now, there have been no reports of dimension compensation for quartz device fabrication. Therefore, this paper studied the wet etching process of Z-cut quartz crystal substrates for making deep trench patterns using Au/Cr metal hard masks and proposed the first quartz fabrication dimension compensation strategy. The size effect of various sizes of hard mask patterns on the undercut developed in wet etching was experimentally investigated. Quartz wafers masked with initial vias ranging from 3 μm to 80 μm in width were etched in a buffered oxide etch solution (BOE, HF:NH4F = 3:2) at 80 °C for prolonged etching (>95 min). It was found that a larger hard mask width resulted in a smaller undercut, and a 30 μm difference in hard mask width would result in a 17.2% increase in undercut. In particular, the undercuts were mainly formed in the first 5 min of etching with a relatively high etching rate of 0.7 μm/min (max). Then, the etching rate decreased rapidly to 27%. Furthermore, based on the etching width compensation and etching position compensation, new solutions were proposed for quartz crystal device fabrication. And these two kinds of compensation solutions were used in the fabrication of an ultra-small quartz crystal tuning fork with a resonant frequency of 32.768 kHz. With these approaches, the actual etched size of critical parts of the device only deviated from the designed size by 0.7%. And the pattern position symmetry of the secondary lithography etching process was improved by 96.3% compared to the uncompensated one. It demonstrated significant potential for improving the fabrication accuracy of quartz crystal devices.

2D Analysis and Simulation of Quartz Crystal Etch Penetration by Revisiting a Previous Geometric Method

Etching Rate Analysis Model Based on Quartz Bond Angle Characteristics

Size-Effect-Based Dimension Compensations in Wet Etching for Micromachined Quartz Crystal Microstructures

Deep Reactive Ion Etching of Z-Cut Alpha Quartz for MEMS Resonant Devices Fabrication

Evolutionary continuous cellular automaton for the simulation of wet etching of quartz

Three-dimensional cellular model for profile simulation of ion etching process

Evolutionary Kinetic Monte Carlo method for the simulation of anisotropic etching of Z-cut, at-cut and BT-cut quartz

Development of quartz etching database and 3-D micromachining simulation system

A Two-step Wet Etching Process of PZT Thin Film With Ultra-low Undercut for MEMS Applications

Chemical Etching Processes at the Dynamic GaAs/Electrolyte Interface in the Electrochemical Direct-Writing Micromachining

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.

Micromachining process simulation using a continuous cellular automata method

Numerical study of aperture shape effects in deep cryogenic etching of silicon

Modeling and Simulation of Silicon Dry Etching

A cellular automaton-based simulator for silicon anisotropic etching processes considering high index planes

A Systematic Study on Dry Etching Process of Germanium for Ge 3D-Fets Applications

Anisotropic-etching process simulation system MICROCAD analyzing complete 3D etching profiles of single crystal silicon

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

Recent Efforts in Modelling Combined Rate, Size and Thermal Effects on Single Crystal Strength

Micromachining of quartz plates: determination of a database by combined stereographic analysis and 3-D simulation of etching shapes

SACE Scanning Process Assisted with Ultrasonic Vibration on Quartz Glass