Abstract:Microfabrication technology with quartz crystals is gaining importance as the miniaturization of quartz MEMS devices is essential to ensure the development of portable and wearable electronics. However, until now, there have been no reports of dimension compensation for quartz device fabrication. Therefore, this paper studied the wet etching process of Z-cut quartz crystal substrates for making deep trench patterns using Au/Cr metal hard masks and proposed the first quartz fabrication dimension compensation strategy. The size effect of various sizes of hard mask patterns on the undercut developed in wet etching was experimentally investigated. Quartz wafers masked with initial vias ranging from 3 μm to 80 μm in width were etched in a buffered oxide etch solution (BOE, HF:NH4F = 3:2) at 80 °C for prolonged etching (>95 min). It was found that a larger hard mask width resulted in a smaller undercut, and a 30 μm difference in hard mask width would result in a 17.2% increase in undercut. In particular, the undercuts were mainly formed in the first 5 min of etching with a relatively high etching rate of 0.7 μm/min (max). Then, the etching rate decreased rapidly to 27%. Furthermore, based on the etching width compensation and etching position compensation, new solutions were proposed for quartz crystal device fabrication. And these two kinds of compensation solutions were used in the fabrication of an ultra-small quartz crystal tuning fork with a resonant frequency of 32.768 kHz. With these approaches, the actual etched size of critical parts of the device only deviated from the designed size by 0.7%. And the pattern position symmetry of the secondary lithography etching process was improved by 96.3% compared to the uncompensated one. It demonstrated significant potential for improving the fabrication accuracy of quartz crystal devices.

Development of quartz etching database and 3-D micromachining simulation system

Anisotropic-etching process simulation system MICROCAD analyzing complete 3D etching profiles of single crystal silicon

Development of an orientation-dependent anisotropic etching simulation system MICROCAD

Micromachining of quartz plates: determination of a database by combined stereographic analysis and 3-D simulation of etching shapes

Simulation of three-dimensional etch profile of silicon during orientation dependent anisotropic etching

Evolutionary Kinetic Monte Carlo method for the simulation of anisotropic etching of Z-cut, at-cut and BT-cut quartz

Simulation of two-dimensional etch profile of silicon during orientation-dependent anisotropic etching

Dynamic Process of Wet Etching Using BOE Solutions to Control the Etch Rate, Roughness, and Surface Morphology of a Z-cut Α-Quartz Wafer

Etching Rate Analysis Model Based on Quartz Bond Angle Characteristics

Research on a Micro-Processing Technology for Fabricating Complex Structures in Single-Crystal Quartz

Cavity Etching Evolution on the A-plane of Sapphire Crystal in Molten KOH Etchant

Evolutionary continuous cellular automaton for the simulation of wet etching of quartz

Etching Quartz with Inductively Coupled Plasma Etching Equipment

Size-Effect-Based Dimension Compensations in Wet Etching for Micromachined Quartz Crystal Microstructures

A Systematic Study on Dry Etching Process of Germanium for Ge 3D-Fets Applications

Application of the evolutionary kinetic Monte Carlo method for the simulation of anisotropic wet etching of sapphire

Micromachining process simulation using a continuous cellular automata method

Evolutionary Kinetic Monte Carlo Simulation of Anisotropic Wet Etching of Sapphire at Different Concentrations and Temperatures

Deep Reactive Ion Etching of Z-Cut Alpha Quartz for MEMS Resonant Devices Fabrication

Chemical Etching Processes at the Dynamic GaAs/Electrolyte Interface in the Electrochemical Direct-Writing Micromachining

Study of anisotropic etching of (1 0 0) Si with ultrasonic agitation