Abstract:Microfabrication technology with quartz crystals is gaining importance as the miniaturization of quartz MEMS devices is essential to ensure the development of portable and wearable electronics. However, until now, there have been no reports of dimension compensation for quartz device fabrication. Therefore, this paper studied the wet etching process of Z-cut quartz crystal substrates for making deep trench patterns using Au/Cr metal hard masks and proposed the first quartz fabrication dimension compensation strategy. The size effect of various sizes of hard mask patterns on the undercut developed in wet etching was experimentally investigated. Quartz wafers masked with initial vias ranging from 3 μm to 80 μm in width were etched in a buffered oxide etch solution (BOE, HF:NH4F = 3:2) at 80 °C for prolonged etching (>95 min). It was found that a larger hard mask width resulted in a smaller undercut, and a 30 μm difference in hard mask width would result in a 17.2% increase in undercut. In particular, the undercuts were mainly formed in the first 5 min of etching with a relatively high etching rate of 0.7 μm/min (max). Then, the etching rate decreased rapidly to 27%. Furthermore, based on the etching width compensation and etching position compensation, new solutions were proposed for quartz crystal device fabrication. And these two kinds of compensation solutions were used in the fabrication of an ultra-small quartz crystal tuning fork with a resonant frequency of 32.768 kHz. With these approaches, the actual etched size of critical parts of the device only deviated from the designed size by 0.7%. And the pattern position symmetry of the secondary lithography etching process was improved by 96.3% compared to the uncompensated one. It demonstrated significant potential for improving the fabrication accuracy of quartz crystal devices.

Micromachining of quartz plates: determination of a database by combined stereographic analysis and 3-D simulation of etching shapes

Development of quartz etching database and 3-D micromachining simulation system

On-machine Measurement of a Slow Slide Servo Diamond-Machined 3D Microstructure with a Curved Substrate

Stereovision System For 3-D Measurement Of Mems Components

Micro-Fabrication and Monitoring of Three-Dimensional Microstructures Based on Laser-Induced Thermoplastic Formation

Etching Rate Analysis Model Based on Quartz Bond Angle Characteristics

A New Diamond Machining Approach for Extendable Fabrication of Micro-Freeform Lens Array

Evaluation on Ground Surface Accuracies of Large-Depth and Steeply Micro-Structured SiC Surfaces

Development of an orientation-dependent anisotropic etching simulation system MICROCAD

Evolutionary Kinetic Monte Carlo method for the simulation of anisotropic etching of Z-cut, at-cut and BT-cut quartz

Micromachining 3d Hemispherical Features in Silicon Via Micro-Edm

Micromachining process simulation using a continuous cellular automata method

Deep Reactive Ion Etching of Z-Cut Alpha Quartz for MEMS Resonant Devices Fabrication

Some effects of chemical etching on the surface texture of SC-cut and RT-cut quartz plates

Ductile machining of single-crystal silicon for microlens arrays by ultraprecision diamond turning using a slow tool servo

Anisotropic-etching process simulation system MICROCAD analyzing complete 3D etching profiles of single crystal silicon

Micromachining of monocrystalline silicon and glass for chemical analysis systems A look into next century's technology or just a fashionable craze?

Numerical study of aperture shape effects in deep cryogenic etching of silicon

Microwave sintering of complex shapes: From multiphysics simulation to improvements of process scalability

Evolutionary continuous cellular automaton for the simulation of wet etching of quartz

Size-Effect-Based Dimension Compensations in Wet Etching for Micromachined Quartz Crystal Microstructures