Abstract:The temperature of the water wall in the furnace chamber is extremely important for the daily operation of a boiler. Considering the high temperature and dusty environment in the furnace, a temperature measurement device mainly composed of four parts (armored temperature sensor, in-furnace heat-collecting block, out-furnace fixing base, and protective cannula) was designed in this study, which could be used to directly obtain the temperature of the in-furnace water-wall. Numerical simulations of temperature measurement devices with different heat-collecting block structures were carried out using the computer fluid dynamics method. After comparing the measurement accuracy and considering the practical application scenarios, the optimized heat-collecting block structure with a specific expansion gap (0.5 mm wide and 4 mm deep) was selected for practical application. Such a temperature measurement device was then applied to a 1000 MW ultra-supercritical coal-fired boiler in China, and the tested in-furnace water-wall temperature data were in good agreement with relevant research. Compared with the conventional temperature measurement device arranged outside the furnace, the in-furnace water-wall temperature-measurement device adopted in this study has a more sensitive response characteristic and can directly reflect the temperature of the water wall inside the furnace. In addition, it can also reflect the local slag formation state of the water wall and has a long service life.

Temperature Test and Analysis of External Pipe-wall of Heating Surface in High Temperature Part of Boiler

Corrosion Failures of High Temperature Heat Pipes

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Safety Testing and Analysis of the Header of the Drawn Boiler with a Small Diameter and a Large Wall Thickness

Analysis of the Heating-surface Wall Temperature Characteristics of a CFB (circulating Fluidized Bed) Boiler Wing Wall

Application study on enamel heat exchange tube in GGH of coal-fired units with ultra-low flue gas emission

BURST ANALYSIS OF HIGH TEMPERATURE RE-HEATER PIPE OF POWERSTATION

FRACTURE ANALYSIS OF THE PIPES FOR EXCHANGING BOILER'S SURPLUS HEAT

Temperature Field Research of High-pressure Heater Based on ANSYS

Numerical Study and Structural Optimization of Water-Wall Temperature-Measurement Device for Ultra-Supercritical Boiler

ANALYSIS OF TEMPERATURE FIELD AND THERMAL STRESS FOR EXTERNALLY CONNECTED PIPE SOCKETS OF REHEATER BY USING THE FINITE ELEMENT METHOD

Design and Experimental Analysis of Grooved Flat Aluminum Heat Pipe

Measuring Method of Inner Wall Temperature Fluctuations for Thermal Fatigue in T-junction Pipe

Experimental Study on Temperature, Heat Flux, Strain and Stress Distribution of Boiler Water Walls

Experimental Study on the Distribution of Temperature and Deformation in the Water Walls of an Opposed Firing Boiler under Variable Load Conditions

The Temperature and Thermal Stress Analysis of Steam Pipe and Correlative Branch Pipe with Finite Element Method

Measurement and Its Error Analysis of Heat Flux in Water Wall

Fluctuation Characteristics and Data Processing Method of Infrared Measurement Signal of Superheaters Inner Wall Temperature in Utility Boiler

INVESTIGATION ON THE TUBE WALL TEMPERATURE AND CRITICAL HEAT FLUX FOR HIGH PRESSURE STEAM-WATER TWO-PHASE FLOW IN INTERNALLY RIBBED TUBES

Analysis on a Burst High-Temperature-Reheater Pipe in a Power Plant

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT