Abstract:This article presents a wideband millimeter-wave (mmWave) receiver front-end that covers the frequency range from 43 to 97 GHz, supporting the operation in the major parts of the V-, E-, and W-bands. The front-end incorporates a passive mixer-first topology to achieve high linearity and wideband performance. The front-end adopts I/Q generation at the RF port, using a coupled-line coupler (CLC), rather than at the local oscillator (LO) port to mitigate the crosstalk of the overlapping I/Q LO signals especially present at high frequencies. The CLC at the RF input facilitates ultrawide band input matching. The front-end implements the multi-gate gm3 cancellation technique at the IF amplifiers to preserve the linearity and provide gain at the IF section. Image rejection capabilities using a current mode transformer-based IF 90° coupler are implemented on chip and demonstrated with measurements. The front-end prototype is fabricated on the GlobalFoundries 22-nm FD-SOI CMOS process and it demonstrates an ultra-wideband performance across the frequency range 43–97 GHz (2.25:1 bandwidth) with image rejection of up to 32 dB, IIP3 of 1.6–5.2 dBm, and gain of 15 dB. The implementation used is low-IF topology with 3.8-GHz IF frequency and 1-GHz bandwidth. Furthermore, the measurement results show that the front-end supports high-speed modulated signals of up to 6-Gbps 64QAM modulation data.

A 0.13&#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer

A group-selected and gain controllable CMOS active mixer for UWB applications

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

A Low Power 35 Ghz Cmos Uwb Receiver Front-End

A 0.13μm CMOS Low-Voltage High-Linearity Mixer for UWB Receiver

A 0.18 Mu M Cmos High Linearity Flat Conversion Gain Down-Conversion Mixer For Uwb Receiver

A 0.18μm CMOS high linearity flat conversion gain down-conversion mixer for UWB receiver

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A Single-in-differential-out CMOS RF Front-End for UWB 6&#x2013;9ghz Applications

Fully Differential CMOS LNA and Down-Conversion Mixer for 3-5 GHz MB-OFDM UWB Receivers

A Robust Cmos Rf Front-End Design for 3.1-4.8Ghz Mb-Ofdm Uwb System

A UWB Mixer with a Balanced Wide Band Active Balun Using Crossing Centertaped Inductor

A 43–97-GHz Mixer-First Front-End With Quadrature Input Matching and On-Chip Image Rejection

A High Conversion Gain Wideband Mixer Design for UWB Applications

Design of a High-Linearity RF Front-End with IP2 Calibration for SAW-less WCDMA Receivers.

A high gain, wide band (2–10 GHz), and low noise active balun merged folded mixer for the full-band UWB application

Design of 6.2—9.4 GHz DC-OFDM UWB Receiver RF Front-End

A 0.07–3 GHz Wideband Front-End for SDR Receiver with 2.3 Db NF and 12 Dbm IIP<sub>3</sub> in 65 Nm CMOS

A 3.1–4.8 GHz CMOS receiver for MB-OFDM UWB

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A 0.13&amp;#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer