Abstract:The use of fully premixed combustion in small gas boilers can improve denitrification efficiency. On the basis of fully premixed combustion, adding flame stabilizers inside the boiler can further reduce production of oxides of nitrogen. Four types of flame-stabilizing baffles were added at a certain position inside the furnace after the fully premixed burner. Experiments were conducted separately on the Noporous baffle, and numerical calculations were performed for 36 operating conditions of the four baffles. The experimental results and numerical calculations indicate that under experimental conditions, NOx emissions were all below 40 mg/m3, and the net heat efficiency of the boiler was above 80%. Under a maximum firing rate, CO emissions are below 20 ppm, and the minimum error between the calculated and experimental values is 2.2%. The calculation error of CO emissions under various working conditions does not exceed 6.8%, indicating that the impact of different-shaped baffles on CO emissions is relatively small. When installing a Nonporous baffle, the error between the experimental and calculated exhaust temperature values under minimum firing rates is 6.6%, the error between the calculated and measured values under middle firing conditions is 2.9%, and the error between the calculated and measured values under maximum firing rate conditions is 3.0%. Among the four different partition conditions, the exhaust temperature of the Nonporous baffle is the lowest. Under the same excess air coefficient, the pressure in the furnace for the middle and maximum firing rate is higher than that of the minimum firing rate, and the experimental values are in good agreement with the calculated values. When installing the Strip baffle, the calculated CO2 emission is the lowest. The experimental results show that the NOx in the flue gas inside the furnace is mainly NO, and the NO content exceeds 75%, reaching a maximum of 85%. The experimental results show that the minimum NOx emission value is 26.9 mg/m3. The error between the measured and calculated NOx values when installing a Nonporous baffle is 20.4%. All of the above indicate that installing a flame-stabilizing baffle at an appropriate position in the furnace can further reduce NOx emissions, and the optimization amplitude is related to the shape of the baffle.

Flow and Thermal Mixing Characteristics of a Multi-Jet Bypass Flue with Main Flue Baffles

Mixing Performance of Preheated Flue Gas Entering Selective Catalytic Reactor under Low Loads

Research on Optimization of Flow Field of Denitration System of 600MW Unit and Modification of Fine Ammonia Injection

Experimental Investigation on the Mixing Performance of Heating Gas into the Low Temperature Sintering Flue Gas Selective Catalyst Reaction Facilities

Experimental and Numerical Simulation Research on Different Shapes of Flame-Stabilizing Baffles in the Furnace

NEW TYPE VORTEX AMMONIA-SPRAYING AND MIXING FACILITY USED FOR DENITRIFICATION SYSTEM AS WELL AS NUMERICAL SIMULATION OF THE FLOW FIELD

Experimental investigation of the performance attributes of a double pipe heat exchanger equipped with baffles of conventional or flower layouts

Numerical Study of Mixing Characteristics in Hyper-burner Mixing Chamber

Influence of baffles on mixing and heat transfer characteristics in an internally heated rotating drum

Flow maldistribution and heat transfer non-uniformity with an inlet baffle structure in regenerative cooling channels

Structure optimization and flow field characteristics of baffle-type impinging stream reactor

Study on Targeted Influence of Annular Porous Media and Rotating Impeller on Thermal Mixing in T-Junctions

Effects of Tertiary Air Damper Opening on Flow, Combustion and Hopper Near-Wall Temperature of a 600 MWe Down-Fired Boiler with Improved Multiple-Injection Multiple-Staging Technology

Numerical Investigation of the Flow and Infrared Radiation Characteristics of Nozzles with Transverse Jets of Different Shapes

Promotion of the Mixing Performance of Heated Gas and Low-Temperature Sintering Gas in Selective Catalytic Reaction Facilities

Experimental thermal-hydraulic performances of heat exchangers with different baffle patterns

Experimental and numerical study on flow mixing and combustion characteristics of a novel multibypass integrated combustor

Thermal-hydraulic performance and design parameters in a curved-corrugated channel with L-shaped baffles and nanofluid

Flow Characteristics in the Nozzle of a Gas Re-burning and Low-NOx Burners

Numerical study of mixing characteristic between flue and droplet at 410t/h coal-fired boiler SNCR system

Experimental Air/particle Flow Characteristics of an 80,000 Nm3/h Fly Ash Entrained-Flow Gasifier with Different Multi-Burner Arrangements