Abstract:The micro-mixing combustor exhibits the advantages of rapid and uniform mixing of fuel and air, high safety, and low emissions, showing broad prospects in the utilization of hydrogen energy. The micro-tube serves as a fundamental unit of the micro-mixing combustor. This paper places emphasis on the mixing mechanism of hydrogen and air in the micro-tube, conducting a thorough analysis of the mixing phenomena in micro-tubes with different geometric configurations using the large eddy simulation (LES) method. When employing the fuel single-hole vertical injection structure, the micro-tube jet in cross-flow (JICF) generates vortex structures similar to those in open-space JICF. The counter-rotating vortex pair (CVP) plays a crucial role in the mixing process, but its mixing ability in the jet direction is not strong enough, leading to lower fuel concentration near the wall and increased mixing deficiency. At higher fuel injection speeds, the fuel jet impacts the wall and wraps around it, enclosing the air and promoting mixing. Increasing the number of fuel holes to 2, under constant speed ratio, results in a phenomenon of mutually opposing fuel jets, squeezing the fuel to the sides of the micro-tube. This enhances the local near-wall fuel concentration and reduces mixing deficiency. However, when using 3 or 4 fuel holes, the jets no longer oppose due to reduced penetration depth, and poor diffusion of fuel near the wall remains the main reason for mixing deficiency. To improve near-wall fuel concentration, structures with the jet at a certain angle to the diameter are studied. Under the influence of the wall, CVP evolves into a single vortex, and the fuel rotates along the wall. When the jet is inclined at 45 degrees to the diameter, mixing deficiency rapidly decreases. It can achieve relatively ideal mixing effects, with fuel and air uniformly mixed downstream of the fuel hole at approximately 15 times the tube diameter.

Promotion of the Mixing Performance of Heated Gas and Low-Temperature Sintering Gas in Selective Catalytic Reaction Facilities

Experimental Investigation on the Mixing Performance of Heating Gas into the Low Temperature Sintering Flue Gas Selective Catalyst Reaction Facilities

Numerical Investigation of H2/air Mixing Characteristics in Micro-Tubes with Different Geometric Configurations

Mixing Performance of Preheated Flue Gas Entering Selective Catalytic Reactor under Low Loads

Mixing Behaviors of Jets in Cross-Flow for Heat Recovery of Partial Oxidation Process

Experimental Study on Gas–liquid Dispersion and Mass Transfer in Shear-Thinning System with Coaxial Mixer

Effects of Reactant Injection Conditions on Diffusion Combustion of Natural Gas in a Laboratory-scale Combustor

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

A Numerical Study of the Fuel/air Mixing Law Specific to the Premixing Section of a Gas Turbine Combustor

Study of the Semi-premixed Combustion Mixed Characteristics of a Reciprocal Porous Medium Heater

Analysis and Experiments about the Characteristics of Mixing Process in the Premixed Gas Turbine

Research on combustion performance of a micro-mixing combustor for methane-fueled gas turbine

New insights into the effects of methane and oxygen on heat/mass transfer in reactive porous media

Experimental and numerical investigations on flow field characteristics of pintle injector

Mixing effects of high-speed jets in gas-solid riser and downer reactors

Enhancing thermal mixing of supercritical water through a confined co-flowing planar jet

Experimental Investigation on Flow Structures and Mixing Mechanisms of a Gas–solid Burner Jet

Experimental study on control of transverse jet mixing by arrayed plasma energy deposition

The Law of Gas–Liquid Shear Mixing under the Synergistic Effect of Jet Stirring

Comparative tests of mixing performance of hot gas plenum with different thermal mixing element in 10MW HTR test module

Cold flow characteristics of a novel high-hydrogen Micromix model burner based on multiple confluent turbulent round jets