Abstract:Safety demonstration tests on the 10 MW High Temperature Gas-cooled Reactor-Test Module (HTR-10) were conducted to verify the inherent safety characteristics of modular High Temperature Gas-cooled Reactors (HTGRs) as well as to obtain the reactor core and primary cooling system transient data for validation of HTGR safety analysis models and codes. As one of these safety demonstration tests, a simulated anticipated transient without scram (ATWS) test called loss of forced cooling by tripping the helium circulator without reactor scram was carried out at 100% rated power level in July, 2005.This paper simulates the reactor transient behaviour during the test by using the THERMIX code system. The reactor power transition and a comparison with the test result are presented. Owing to the negative temperature coefficient of reactivity, the reactor undergoes a self-shutdown after the stop of the helium circulator and keeps subcritical till the end of the test. Due to the loss of forced cooling, the residual heat is slowly transferred from the core to the Reactor Cavity Cooling System (RCCS) by conduction, radiation and natural convection. The thermal response of this heat removal process is investigated. The calculated and test temperature transients of the measuring points in the reactor internals are given and the differences are preliminarily discussed. With respect to the safety features of the HTR-10, it is of most importance that the maximum fuel center temperature is always lower than 1230 degrees C which is the limited value at the first phase of the HTR-10 project.The simulation and test results show that the HTR-10 has the built-in passive safety features, and the THERMIX code system is applicable and reasonable for simulating and analyzing the helium circulator trip ATWS test.

Comparative tests of mixing performance of hot gas plenum with different thermal mixing element in 10MW HTR test module

Model Tests of Coolant Thermal Mixing in the HTR-10 Hot Gas Plenum

Thermal mixing performance of the coolant channel in core bottom of the HTR-10

Thermal mixing similarities for the hot gas plenum of the 10 mw high temperature gas cooled reactor

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Similarity Analysis for Hot Gas Mixing Experiment of Outlet of HTR-PM Reactor Core

Thermal Mixing Performance of Mixing Structure at Reactor Outlet of HTR-PM under Complex Conditions

Mechanism and experimental study of thermal mixing of fluid with different temperature

Performance of Thermal Mixing Structure of HTR-PM Regarding Bypass Flow and Power Effect

Experiment Study on Thermal Mixing Performance of HTR-PM Reactor Outlet

Thermal Mixing Test Of Coolant In The Core Bottom Structure Of A High-Temperature Engineering Test Reactor

Helium test loop and test section of hot gas duct

Thermal Mixing of Coolant Flows in a High-Temperature Gas-Cooled Reactor Core (1st Report, Two-jet Mixing Experiments in a Cavity of a Plenum Block)

Primary System Aerodynamic Characteristics and Associated Circulator Operational Performance of Htr-10

Simulation of the HTR-10Primary Mass Flow Variation Test

High temperature performance test of hot gas duct of 10 MW high temperature gas-cooled reactor

Temperature Response of the HTR-10 during the Power Ascension Test

Thermal Hydraulic Calculation of the HTR-10 for the Initial and Equilibrium Core

Experimental Study on the Residual Heat Removal System in HTR-10

ICONE23-1865 NUMERICAL SIMULATION OF HOT GAS MIXING WITH LEAKAGE FLOW AT HTR-PM REACTOR CORE OUTLET

Simulation And Analysis Of Helium Circulator Trip Atws Test At Full Power On The Htr-10