Abstract:Since the middle of 1980's, a research program on heating reactor has been carried out at Institute of Nuclear Energy Technology (INET) of Tsinghua University in China, the heating reactor is a light water cooled, integral type natural circulation reactor with low system pressure and low core exit quality, it has the passive safety features and other advanced characteristics of the next generation reactors. Because of a relatively long riser and low system pressure, a small quality perturbation at the exit of the core will lead to a relatively large variation of void fraction in the riser, so will the driving force. All of the above features made it very different from the typical PWRs and BWRs. In order to guarantee the safe operation of the heating reactor, a full scale test loop HRTL-200, simulating HR-200 heating reactors in main geometry and operation parameters, was constructed and operated under the broad test conditions covering the 200 MW heating reactor operation conditions at INET. The HRTL-200 test facility, some of steady-state and two-phase flow instability test results from the test facility and the consideration how to choose the optimal design parameters for the heating reactors are shown in this paper. The range of experimentally studied parameters are: the system pressure is from 1.0 to 4.0 MPa, the largest heat flux is about 50 W/cm2, and the quality at the exit of the test section is less than 6%.

Experiment Study on Thermal Mixing Performance of HTR-PM Reactor Outlet

Thermal Mixing Performance of Mixing Structure at Reactor Outlet of HTR-PM under Complex Conditions

Similarity Analysis for Hot Gas Mixing Experiment of Outlet of HTR-PM Reactor Core

Performance of Thermal Mixing Structure of HTR-PM Regarding Bypass Flow and Power Effect

Mechanism and experimental study of thermal mixing of fluid with different temperature

ICONE23-1865 NUMERICAL SIMULATION OF HOT GAS MIXING WITH LEAKAGE FLOW AT HTR-PM REACTOR CORE OUTLET

Comparative tests of mixing performance of hot gas plenum with different thermal mixing element in 10MW HTR test module

Investigation on Numerical Simulation for Hot Gas Mixing Structure of HTR-PM by Considering Leakage Flow

Thermal Mixing Test Of Coolant In The Core Bottom Structure Of A High-Temperature Engineering Test Reactor

Model Tests of Coolant Thermal Mixing in the HTR-10 Hot Gas Plenum

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Thermal mixing performance of the coolant channel in core bottom of the HTR-10

Thermal mixing similarities for the hot gas plenum of the 10 mw high temperature gas cooled reactor

Steady-state Thermal Fluids Analysis for the HTR-PM Equilibrium Core

Thermalhydraulic Investigation Using a Test Facility Simulating 200 MW Integral Heating Reactor

Theoretical Analysis of Effective Thermal Conductivity for the Chinese HTR-PM Heat Transfer Test Facility

Simulation of Thermal-Hydraulic Process in Reactor of HTR-PM Based on Flow and Heat Transfer Network

Thermal–hydraulic feasibility analysis on uprating the HTR–PM

Simulation of Thermal-Hydraulic Process of Reactor in HTR-PM

Experimental and Numerical Investigation of the Flow Measurement Method Utilized in the Steam Generator of Htr-Pm

Analysis of impact of mixing flow on the pebble bed high temperature reactor