Abstract:Predictions of various kinds and distributions of bypass flows are important to the thermal hydraulic design of the HTR-PM (High Temperature gas-cooled Reactor-Pebble-bed Module). In the reactor core, gaps among graphite reflectors are widely distributed and connected, which become typical bypass flow paths interacting with the main flow through the pebble bed. In previous researches, simplified flow network was employed to present the main flow through the pebble bed, and a great many interconnected bypass flow paths, while some irregular gaps were modeled by the computational fluid dynamic (CFD) tools to clarify the resistance coefficients. In present paper, a full CFD model was used to further investigate the bypass flow in the HTR-PM reactor core, which could reveal more local helium flow and heat transfer phenomena if vertical gaps close to pebble bed existed. With separately verified CFD models, the vertical gap bypass flow problem was simulated by the full three-dimension symmetrical model including the helium cooling channel, the cold helium plenum, the cavity above the pebble bed, the bottom reflector, the hot helium plenum and the vertical gap from top to bottom reflectors. Flow distributions in the whole height of active core, as well as radial flow directions along the interface of pebble bed and gap, were focused to find out that the bypass flow rate varied in the vertical gap. For horizontal helium flows, the cold helium mainly flowed into the cavity above the pebble bed while hot helium flowed out of pebble bed. In the full power operation condition, the bypass flow rate ratio was between 0.33% and 1.94% of the total helium flow rate when the gap was consistent with 1.6 mm in width. More gap sizes could be modeled in the future to study the effect to the bypass flow rate ratio.

Investigation on Numerical Simulation for Hot Gas Mixing Structure of HTR-PM by Considering Leakage Flow

ICONE23-1865 NUMERICAL SIMULATION OF HOT GAS MIXING WITH LEAKAGE FLOW AT HTR-PM REACTOR CORE OUTLET

Thermal Mixing Performance of Mixing Structure at Reactor Outlet of HTR-PM under Complex Conditions

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Similarity Analysis for Hot Gas Mixing Experiment of Outlet of HTR-PM Reactor Core

Performance of Thermal Mixing Structure of HTR-PM Regarding Bypass Flow and Power Effect

Analysis of impact of mixing flow on the pebble bed high temperature reactor

Numerical investigation of the HTR-PM steam generator entrance structure influence to the flow distribution

Experiment Study on Thermal Mixing Performance of HTR-PM Reactor Outlet

Experimental and Numerical Investigation of the Flow Measurement Method Utilized in the Steam Generator of Htr-Pm

CFD Investigation of Bypass Flow in HTR-PM

Numerical Investigation of Mass Mixing in the Reactor Core of a Pebble Bed HTGR

Study on the Break Accidents of the Htr-Pm Primary Loop

Numerical Study of the Particle-Scale Heat Transfer in the HTR-PM Pebble Bed Based on GPU-DEM

Numerical Study of the Effect of Particle Size on Pebble Flow in the HTR-PM

Preliminary Analyses of Single Droplet Evaporation and Movement in the Steam Generator of HTR-PM

Investigation of Flow and Heat Transfer in the Pebble Bed of the High Temperature Gas-cooled Reactor

Analysis Of Bypass Effect On A 250 Mw High Temperature Gas-Cooled Reactor

Numerical Simulation of Flow Distribution in the Lower Plenum of NHR200-II

Analysis of Diffusion Process and Influence Factors in the Air Ingress Accident of the HTR-PM

Numerical Simulation of Flow Field in Hot Gas Chamber of High-Temperature Gas-Cooled Reactor