Abstract:During the operation of the High Temperature Gas-cooled Reactor (HTGR), the hot-spot temperature in the reactor core must be lower than the maximum permissible temperature of the fuel elements and the materials of construction, so that the reactor kept safe. However, no fixed temperature-measuring devices can be set in a pebble-bed core. A special spherical temperature-measuring device is adopted to make sure it brings as small impact to the reactor operation as possible. There are several metal wires with different melting points inside. The graphite thermometric balls will be put onto the top of HTR-10 reactor core, and they record and reflect the highest temperature in different positions in the core when flowing in the pebble bed. Before the reactor core temperature-measuring experiment of HTR-10, we must study the heat transfer characteristics of the graphite thermometric sphere to find out the relationship of the melting conditions and the temperature in the reactor core. A 3-D model of the graphite thermometric ball is established, and CFD method is adopted to research and figure out the thermal equilibrium time and temperature difference between the metal wires in the ball and the hot fluid outside the balls. Multiple situations are simulated, and the heat transfer process of the thermometric sphere is comprehensively studied. The heat convection is certified the most important aspect. Thermal equilibrium can be achieved within 19 minutes, far shorter than the period while the spheres flowing through the core. The simulation results can also applied to derive the thermal fluid temperature backward.

Thermal mixing performance of the coolant channel in core bottom of the HTR-10

Thermal Mixing Test Of Coolant In The Core Bottom Structure Of A High-Temperature Engineering Test Reactor

Comparative tests of mixing performance of hot gas plenum with different thermal mixing element in 10MW HTR test module

Model Tests of Coolant Thermal Mixing in the HTR-10 Hot Gas Plenum

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Thermal Mixing Performance of Mixing Structure at Reactor Outlet of HTR-PM under Complex Conditions

Thermal Hydraulic Calculation of the HTR-10 for the Initial and Equilibrium Core

Mechanism and experimental study of thermal mixing of fluid with different temperature

Numerical and Experimental Studies for Thermal Mixing of Coolant in a Core Bottom Structure of HTTR.

Performance of Thermal Mixing Structure of HTR-PM Regarding Bypass Flow and Power Effect

Thermal mixing similarities for the hot gas plenum of the 10 mw high temperature gas cooled reactor

Simulation of the HTR-10Primary Mass Flow Variation Test

Experiment Study on Thermal Mixing Performance of HTR-PM Reactor Outlet

Temperature Response of the HTR-10 during the Power Ascension Test

Thermal Mixing of Coolant Flows in a High-Temperature Gas-Cooled Reactor Core (1st Report, Two-jet Mixing Experiments in a Cavity of a Plenum Block)

RESEARCH ON HEAT TRANSFER CHARACTERISTICS OF THE THERMOMETRIC SPHERE IN HTR-10

Experimental Study on the Residual Heat Removal System in HTR-10

Benchmark Calculation for the Steady-State Temperature Distribution of the Htr-10 under Full-Power Operation

Similarity Analysis for Hot Gas Mixing Experiment of Outlet of HTR-PM Reactor Core

Thermal Behavior of the HTR-10 under Combined PLOFC and ATWS Condition Initiated by Unscrammed Control Rod Withdrawal

Primary System Aerodynamic Characteristics and Associated Circulator Operational Performance of Htr-10