Abstract:Very-high-temperature gas-cooled reactor (VHTR) has good inherent safety and is one of the six reactor technologies of Generation IV nuclear energy systems. The ultra-high core outlet temperature makes VHTR suitable for process heat applications such as hydrogen production. The intermediate heat exchanger (IHX) is the key equipment for energy transfer between VHTR and the process heat application system. To verify the the high temperature performance of IHX, it is generally necessary to set up a high temperature helium test system to conduct a series of performance tests. In this experimental system, a well-behaved water cooler needs to be designed to cool down the high-temperature helium in the experimental loop to ensure the safety of the experimental system. In the present study, the effect of the cooling water flow rate G, the cooling water injection position L, and the lower heat exchange tubes material were analyzed. The results show that increasing the flow rate of the cooling water, the maximum temperature of the tube sheet T-max decreases and the temperature gradient in the flow direction Delta T-y increases. T-max increases first and then decreases with the increasing L. There exists an optimal cooling water injection position between L=175mm and 225mm. The variation of Delta T-y is the opposite. The use of ceramic instead of steel reduces T-max by about 295K and reduces Delta T-y by half. Subsequent research and optimization on structure parameters of the water cooler are expected to further improve the cooling performance.

High temperature performance test of hot gas duct of 10 MW high temperature gas-cooled reactor

Helium test loop and test section of hot gas duct

Analysis and Calculation of Structure Strength of Hot Gas Duct in HTR-PM

Experimental Study of Steam Generator Stability of 10MW High Temperature Reactor

Comparative tests of mixing performance of hot gas plenum with different thermal mixing element in 10MW HTR test module

Hydraulic pressure test of pressure vessel of 10 MW high temperature gas-cooled reactor

Design of the Material Performance Test Apparatus for High Temperature Gas-Cooled Reactor

Numerical Simulation of Flow Field in Hot Gas Chamber of High-Temperature Gas-Cooled Reactor

Development and Validation of Helical-Coil-in-fluted-tube Gas Cooler for CO2 Heat Pump Water Heaters

Primary System Aerodynamic Characteristics and Associated Circulator Operational Performance of Htr-10

Experimental Study on the Residual Heat Removal System in HTR-10

Study on water cooler performance for high temperature helium experimental system

Thermal mixing similarities for the hot gas plenum of the 10 mw high temperature gas cooled reactor

Numerical Investigations of Thermal Mixing Performance of a Hot Gas Mixing Structure in High-Temperature Gas-Cooled Reactor

Optimization of Hot Gas Chamber in High Temperature Reactor

Three-dimensional Numerical Investigation of Heat Transfer Process in the Reactor Cavity of HTR-10

Numerical Investigation on Thermal–hydraulic Characteristics of the Helically Corrugated Tube in Intermediate Heat Exchangers for Very-High-temperature Gas-Cooled Reactors

Numerical Analysis of the Hot Spot of the Heat Transfer Tube Wall in an HTGR Helical Tube Once Through Steam Generator

Numerical investigation on the thermal load heterogeneity of multi-assembly helical coil steam generator in high temperature gas-cooled reactor

The design and thermohydraulics study of the HTR-10 High Temperature Helium Experimental Loop

Thermocouple Penetration Assemblies for Pressure Vessel of 10MW High Temperature Gas-Cooled Reactor