Abstract:The reduced inlet flue gas temperature of the selective catalytic reduction (SCR) denitrification device is a significant problem during the low-load operation of boilers. In this study, an experimental system for turbulent thermal mixing of high and low-temperature flue gases was built to study the thermal mixing method in bypass flue gas technology and the effect of the temperature difference and flow rate variation of high and lowtemperature flue gases at low load on the thermal mixing characteristics. The experiments evaluated the thermal mixing characteristics by measuring the temperature field distribution, calculating the inhomogeneity parameters.T, and investigate the multi-jet distribution characteristics. The investigation was carried out more accurately by combining the simulation results. The results show that the tube wall jet combined with the bottom jet method provides the highest warming effect and possesses the lowest mixing non-uniformity parameter. At the location which is 1.25 times the hydraulic diameter of the duct away from the jet pipe, the temperature difference between the mainstream and the jet drops from 270. C to 180. C, causing.T to drop from 0.46 to 0.37. Decreasing the jet velocity and increasing the main flow velocity promote a decrease in.T, indicating that the ratio of jet velocity to main flow velocity and the velocity ratio UJ Um are crucial factors affecting the thermal mixing characteristics, which directly affects the heat transfer between hot and cold fluids. The.T decreases from 0.52 to 0.42 as UJ Um changes from 3.58 to 2.15. This study provides a reference for ensuring the safe and stable operation of SCR denitrification system during the low-load operation of coal-fired boilers.

Mixing Performance of Preheated Flue Gas Entering Selective Catalytic Reactor under Low Loads

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Experimental Investigation on the Mixing Performance of Heating Gas into the Low Temperature Sintering Flue Gas Selective Catalyst Reaction Facilities

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Flow and Thermal Mixing Characteristics of a Multi-Jet Bypass Flue with Main Flue Baffles

Change of Ammonia Escape Rate and SO3 Conversion Rate of SCR Denitration in Full Load Range

Investigating the Optimization Design of Internal Flow Fields Using a Selective Catalytic Reduction Device and Computational Fluid Dynamics

Numerical study of mixing characteristic between flue and droplet at 410t/h coal-fired boiler SNCR system

Low NOx combustion and SCR flow field optimization in a low volatile coal fired boiler

Full-Scale Numerical Investigation of a Selective Noncatalytic Reduction (SNCR) System in a 100 MW Utility Boiler with Complex Chemistry and Decoupling Approach

Denitration Simulation of SNCR System Nozzles at Different Layout Positions in Coal Powder Boilers

Numerical Simulation on Optimization of SCR Denitrification System for Coal-fired Boilers

Optimization of Ammonia Injection Grid in Hybrid Selective Non-Catalyst Reduction and Selective Catalyst Reduction System to Achieve Ultra-Low NOx Emissions

STUDY ON FLOW FIELD OF THE SCR EQUIPMENT FOR A 300 MW UNIT BOILER

Enhancement of SCR denitrification control strategy considering fluegas temperature fluctuation: Fundamental principle and performance evaluation

Experimental Investigation of the Effect of Two Additives on the Characteristics of Low-Temperature Fouling with an In-Situ Measurement Technique

CFD analysis of influencing factors on SCR denitration efficiency of sintering flue gas based on response surface methodology

Promotion of the Mixing Performance of Heated Gas and Low-Temperature Sintering Gas in Selective Catalytic Reaction Facilities

Investigation of the growth and removal of particles in coal-fired flue gas by temperature management

Numerical investigation on the optimized arrangement for high-temperature corrosion after low NOx transformation