Abstract:Denitration (De-NOx) over activated cokes (ACs) for sintering flue gas needs intensification. Gaseous reactions in a gas mixture containing NO, NO2, and NH3, with the effect of O2 concentration and moisture, were taken into consideration in the study of NOx conversion over ACs. Experimental studies on NOx conversion with and without NH3 over ACs were conducted using a fixed-bed reactor at 100 °C. The results demonstrated that moisture significantly affected NOx removal over ACs, especially the NO2 conversion. Under dry conditions, a disproportionation reaction of NO2 over ACs dominated NOx conversion with no NH3, whereas apparent fast selective catalytic reduction (SCR) over the ACs was observed in the presence of NH3. Regardless of the presence of absence of NH3 in wet mixtures, NO2 adsorption on ACs via the disproportionation route dominated the NOx conversion. Increasing the NO2/NO ratio in the simulated flue gas enhanced the NOx conversion rate over ACs. −C(ONO2) deposition on ACs generated by the disproportionation route inhibited NOx conversion with time. O3 oxidation was found to be efficient in increasing the NO2/NO ratio and intensifying the NOx conversion compared with commercially direct NH3-SCR over ACs. Increasing the temperature and decreasing the gas hourly space velocity can promote NOx conversion over ACs after O3 oxidation. NO oxidized with O3 coupled with NH3 spray and continuous regeneration of ACs is a potential method for removing NOx from sintering flue gas.This article has not yet been cited by other publications.

Experimental Investigation on the Mixing Performance of Heating Gas into the Low Temperature Sintering Flue Gas Selective Catalyst Reaction Facilities

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Promotion of the Mixing Performance of Heated Gas and Low-Temperature Sintering Gas in Selective Catalytic Reaction Facilities

Mixing Performance of Preheated Flue Gas Entering Selective Catalytic Reactor under Low Loads

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

NOxremoval Coupled with Energy Recovery in Sintering Plant

Integrated Gas and Solid Model to Determine the Flow Performance in the SCR Reactor

CFD analysis of influencing factors on SCR denitration efficiency of sintering flue gas based on response surface methodology

Research on effect of premixing pulverized coal and lime on sintering flue gas emission

Experimental Investigation on the Conversion of Fuel-N to NOx of Quasi-Particle in Flue Gas Recirculation Sintering Process

Optimization of Ammonia Injection Grid in Hybrid Selective Non-Catalyst Reduction and Selective Catalyst Reduction System to Achieve Ultra-Low NOx Emissions

Collaborative Effect of In-Plasma Catalysis with Sequential Na2SO3 Wet Scrubbing on Co-Elimination of NOx and VOCs from Simulated Sinter Flue Gas

Experimental Investigation of the Effect of Two Additives on the Characteristics of Low-Temperature Fouling with an In-Situ Measurement Technique

Sintering Temperature Effects on SCR Catalyst Characterization and Catalytic Efficiency

Study on CO-NO Removal Mechanism Based on Sintering Flue Gas Circulation

Particle Conditioning for Improving Blockage Resistance of Denitration Catalysts in Sintering Flue Gas

Intensification of NO x Conversion over Activated Coke by Ozone Oxidation for Sintering Flue Gas at Low Temperatures

Study on the Removal of NOX from Sintered Flue Gas by Vanadium Sintered Ore

Influence of Mixing Process on the Selective Non-catalytic Reduction

Simulation of the flow field and the chemical reaction coupling of selective catalytic reduction (SCR) system using an orthogonal experiment

Investigating the Optimization Design of Internal Flow Fields Using a Selective Catalytic Reduction Device and Computational Fluid Dynamics