Abstract:In addition to selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) which are available to remove NO x from flue gas, oxidation method is receiving more and more attention because this method makes it possible to remove NO x and SO 2 from flue gas simultaneously by wet scrubbing. O 3 as a strong oxidant has a high oxidation capacity and it can oxide NO to N 2 O 5 which has a higher water solubility compared with NO 2 . However, it needs a long reaction time and the escape of unreacted ozone may cause secondary pollution. In this study, FeMnCo/Al 2 O 3 catalyst and FeMnCe/Al 2 O 3 catalyst were prepared and applied to enhance the deep oxidation of NO x with ozone and reduce O 3 slip. Effects of various operating parameters such as O 3 /NO ratio, gas residence time, and operating temperature were evaluated, and the results demonstrate that N 2 O 5 began to generate when O 3 /NO ratio was higher than 1.0 and increased with increasing O 3 /NO ratio. Little residual O 3 was formed in the presence of catalyst, while 350 ppm O 3 was measured at the outlet gas when O 3 /NO ratio was controlled at 2.0. The N 2 O 5 conversion efficiency increased with increasing gas residence time and operating temperature, and the highest N 2 O 5 conversion efficiency was achieved at 100°C. Furthermore, the conversion efficiency remained around 90% during 20 h operation over FeMnCe/Al 2 O 3 catalyst with an O 3 /NO ratio of 1.73, a gas residence time of 1.2 s, and a temperature of 100°C. On the other hand, the N 2 O 5 conversion efficiency remained around 80% during 3 h operation over FeMnCo/Al 2 O 3 catalyst. Overall, FeMnCe/Al 2 O 3 catalyst reveals good potential for deep oxidation of NO by O 3 and can be further developed as a viable catalyst for reducing NO emission from industries. Implications : In this study, FeMnCo/Al 2 O 3 catalyst and FeMnCe/Al 2 O 3 catalyst were applied to enhance the deep oxidation of NO into N 2 O 5 with O 3 . The catalysts can improve the conversion of NO into N 2 O 5 , shorten the reaction time and reduce the unreacted O 3 slip, which are beneficial to reduce the size of the reactor required and cost of APCDs (air pollution control devices) in practical application. This method can make it possible to simultaneously remove NO x and SO 2 from flue gas by wet scrubbing for reducing NO emissions from industries, especially small and medium scaled industries, to meet increasingly stringent emission standards.

Intensification of NO x Conversion over Activated Coke by Ozone Oxidation for Sintering Flue Gas at Low Temperatures

NOxremoval Coupled with Energy Recovery in Sintering Plant

Study on the Removal of NOX from Sintered Flue Gas by Vanadium Sintered Ore

Selective Autocatalytic Reduction of NO from Sintering Flue Gas by the Hot Sintered Ore in the Presence of NH3

Study on CO-NO Removal Mechanism Based on Sintering Flue Gas Circulation

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Deep oxidation of NO via catalytic ozonation

Experimental Investigation on the Conversion of Fuel-N to NOx of Quasi-Particle in Flue Gas Recirculation Sintering Process

Study on the mechanism of iron-rich coal gasification slag on NO conversion in high temperature flue gas of cement kiln

Experimental Research on Low Temperature Manganese Oxides SCR Denitrification for Oxy-Fuel Combustion Flue Gas

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

Experimental study on NOx emission characteristics under oxy-fuel combustion

The simultaneous removal of SO2 and NO from flue gas over activated coke in a multi-stage fluidized bed at low temperature

Study on the Denitrification Performance of FexLayOz/activated Coke for NH3-SCR and the Effect of CO Escaped from Activated Coke at Mid-High Temperature on Catalytic Activity.

The development of Fe2O3-based catalysts used for the selective catalytic reduction of NO with NH3: A review

Revealing the Key Role of Acidic Oxygen-Containing Groups on Activated Carbon for Low-Temperature NH3-SCR Denitration

Changes of Nitrate Activity and Byproduct Distribution Characteristics for Synergistic NOx and Dioxin Abatement over V 2 O 5 /AC Catalyst

Efficient simultaneous removal of NOx and CO at low temperatures over integrated Mn2Co1Ox/iron mesh monolithic catalyst via NH3-SCR coupling with CO oxidation reactions

NO Heterogeneous Reduction on Semi-Coke and Residual Carbon with the Presence of O2 and CO

The Industrial Feasibility Of Low Temperature Deno(X) In The Presence Of Sox: A Project Case In A Medium Coking Plant

Optimization of Robust FeMnSmOx Catalyst for Low-Temperature (<150 °C) NH3–SCR of NOx