Abstract:The micro-mixing combustor exhibits the advantages of rapid and uniform mixing of fuel and air, high safety, and low emissions, showing broad prospects in the utilization of hydrogen energy. The micro-tube serves as a fundamental unit of the micro-mixing combustor. This paper places emphasis on the mixing mechanism of hydrogen and air in the micro-tube, conducting a thorough analysis of the mixing phenomena in micro-tubes with different geometric configurations using the large eddy simulation (LES) method. When employing the fuel single-hole vertical injection structure, the micro-tube jet in cross-flow (JICF) generates vortex structures similar to those in open-space JICF. The counter-rotating vortex pair (CVP) plays a crucial role in the mixing process, but its mixing ability in the jet direction is not strong enough, leading to lower fuel concentration near the wall and increased mixing deficiency. At higher fuel injection speeds, the fuel jet impacts the wall and wraps around it, enclosing the air and promoting mixing. Increasing the number of fuel holes to 2, under constant speed ratio, results in a phenomenon of mutually opposing fuel jets, squeezing the fuel to the sides of the micro-tube. This enhances the local near-wall fuel concentration and reduces mixing deficiency. However, when using 3 or 4 fuel holes, the jets no longer oppose due to reduced penetration depth, and poor diffusion of fuel near the wall remains the main reason for mixing deficiency. To improve near-wall fuel concentration, structures with the jet at a certain angle to the diameter are studied. Under the influence of the wall, CVP evolves into a single vortex, and the fuel rotates along the wall. When the jet is inclined at 45 degrees to the diameter, mixing deficiency rapidly decreases. It can achieve relatively ideal mixing effects, with fuel and air uniformly mixed downstream of the fuel hole at approximately 15 times the tube diameter.

Mixing Behaviors of Jets in Cross-Flow for Heat Recovery of Partial Oxidation Process

Hydrodynamics and Local Turbulent Mixing of Submerged, Parallel Liquid Jets: Experiments and CFD Simulations

Flow and Heat Transfer Characteristics in a Microchannel with a Circular Synthetic Jet

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Hydrodynamics in a jet bubbling reactor: Experimental research and mathematical modeling

CFD Simulations of Quenching Process for Partial Oxidation of Methane:Comparison of Jet-in-cross-flow and Impinging Flow Configurations

Mixing augmentation induced by the combination of the oblique shock wave and secondary recirculation jet in a supersonic crossflow

Simulation of Industrial-Scale Gas Quenching Process for Partial Oxidation of Nature Gas to Acetylene

Cold flow characteristics of a novel high-hydrogen Micromix model burner based on multiple confluent turbulent round jets

Numerical and experimental modeling of mixing of impinging jets radially injected into crossflow

Numerical Investigation of H2/air Mixing Characteristics in Micro-Tubes with Different Geometric Configurations

Experimental and numerical investigations on micromixing performance of multi-orifice cross-flow jet mixers

Promotion of the Mixing Performance of Heated Gas and Low-Temperature Sintering Gas in Selective Catalytic Reaction Facilities

Numerical Investigation of the Flow and Infrared Radiation Characteristics of Nozzles with Transverse Jets of Different Shapes

Mixing Enhancement Mechanism of Liquid Jet in Supersonic Crossflow with Gas Throttling

Mixing effects of high-speed jets in gas-solid riser and downer reactors

Flow regimes and mixing characteristics in non-aligned T-jets reactors

The Numerical Simulation of a New Double Swirl Static Mixer for Gas Reactants Mixing

Investigation on the impact of the induced shock wave on the hydrogen mixing augmentation in a supersonic crossflow: A numerical study

Experimental Investigation on the Mixing Performance of Heating Gas into the Low Temperature Sintering Flue Gas Selective Catalyst Reaction Facilities