Abstract:This paper proposes a current detection circuit (CDC) for battery management systems(BMS), comprising a high-performance programmable gain amplifier (PGA) and a 16-bit high-precision, low-power Delta Sigma ADC. The PGA utilizes a two-stage folded cascode operational amplifier with resistive feedback to achieve adjustable gain. The ADC employs a single-loop second-order feedback modulator structure with an oversampling ratio of 256. This design enhances the conversion accuracy and reduces the output noise of the PGA and the switched-capacitor integrator using chopper stabilization techniques. The entire current detection circuit is implemented using the ASMC 0.35um BCD process. The post-simulation results demonstrate that under a 5V power supply voltage, the PGA maintains stable gain from 0-40dB with a phase margin greater than 60 degrees. The low-frequency noise of the PGA is measured at 1.386nV/sqrt(Hz). The transient simulation reveals that when the PGA input voltage varies within the range of 10mV to 300mV, it undergoes different levels of amplification to produce output voltages ranging from 0V to 5V. The PGA exhibits good power supply rejection ratio (PSRR) ranging from 94-112dB at 1KHz. For the ADC, with a signal bandwidth of 1KHz and a sampling rate of 1.024MHz, the effective number of bits (ENOB) reaches 16.58 bits, and the modulator operates at a current of 100uA. The simulation result shows that the error of the current detection is 0.3mV.

Detection and Automatic Adjustment Circuit of Current True Peak Value of the Dynamic Excitation Power Amplifier

Design of a High Precision Chip for Detecting Electric Arc

Improved Design Scheme of High Accuracy Harmonic Detection Based on DSP

A Synchronous Boost Converter with High Speed and High Accuracy Peak Current Control Unit.

Unified Model Based Harmonics and Reactive Current Detection

Harmonic and Reactive Current Synchronous Detecting Method Based on DSP

High-Performance Programmable AC Signal Power Amplifier Using DSP-Based Discrete-Time Sliding Mode Control Technique

Delayless Harmonic Detection Based on DSP with High-Accuracy for Active Power Filter

A 25-31Ghz Compact True Power Detector with >33db Dynamic Range in 40nm Bulk CMOS

A mV-level real-time peak-voltage detection circuit based on differential structure

Harmonic Detection Without Delay Based on Phase Compensation of Fundamental Component

A Fast Dynamic Response Algorithm for Digital Controlled Voltage-Doubler Boost Power Factor Correction Converter

A NEW METHOD FOR REAL-TIME DETECTING HARMONICS AND REACTIVE CURRENTS IN SINGLE-PHASE CIRCUIT

Design of Phase-Shift Signal Generator with High Precision Used for Particulate Detection

A Main Amplifier and Peak Hold Circuit for Periodic Sampling of High Count Rate

Design of Micro Current Detection Circuit for FAIMS

Analysis and design of a weak charge signal amplifier circuit

Weak Current Detection Based On The Faims System

Design and Simulation of Pre-amplification Circuit for IMS Current Signals

Analysis and Comparison of Two Detection Methods for Fundamental Positive Sequence Active Current

A High-precision Current Detection Circuit for Battery Management System.