Abstract:The current rapid development of weak electrical installations has made the monitoring of weak signals increasingly important. For highly sophisticated instruments, the slightest signal deviation will cause terrible and irreparable damage. At present, commercially available multimeters generally have low accuracy, which does not meet the error range required for weak electrical signal monitoring, because it cannot be monitored in real-time, and requires manual handheld data collection. To address the above demands, this study designs and builds a voltage and current signal collector based on the STM32F103 microcontroller. In this case, the DC voltage is designed in the range of −5 V to 5 V, and for the current is from 4 to 20 mA, and the AC voltage from 0 to 5 V can be measured. The measurement results will be displayed on the LCD screen. The collector uses RS485 as the physical transmission interface and the communication protocol uses the Modbus-RTU protocol, which can work properly in the range of 10–24 V DC supply. The analysis of the corresponding requirements is followed by the circuit design to complete the transmission and display of the collected data. The DC voltage measurement part contains the process of boosting and dividing the circuit and then reading it, the current measurement is completed by an isotropic proportional amplifier circuit, and the AC voltage RMS measurement uses the AD637 true RMS conversion chip to realize the circuit, the design contains the software part, the hardware part, and the communication part design. The final device has been tested to meet the national standard of maximum permissible error range within ±0.1 and is suitable for the complex environment envisaged.

Analysis and design of a weak charge signal amplifier circuit

System Design of a Low Noise, Low Offset Instrumentation Amplifier with Chopper Stabilization

Design of a High Precision Chip for Detecting Electric Arc

A Design of Miniaturized High Performance Charge Amplifier

New Small Capacitance Measuring Circuit for Capacitance Sensor

Self-Healing Techniques for Robust mm-Wave Power Amplification

Design of a charge-sensitive amplifier for MEMS piezoelectric hydrophone

A Circuit Design in Piezoelectric Vibration Measurement System

A Novel Low Output Offset Voltage Charge Amplifier for Piezoelectric Sensors

Design and Simulation of Pre-amplification Circuit for IMS Current Signals

Development of a Novel Strategy Based on In-Process Compensation of Charge Leakage for Static Force Measurement by Piezoelectric Force Sensors

Design of Pre-amplifier in Piezoelectric Signal Acquisition

A Low-Cost High-Performance Voltage Sensing Circuit with Proactive Parameter Design Compensation Network for SiC MOSFETs.

Analysis and Design of Piezoelectric Sensor Conditioning Circuit

Design of Contactless Charging Circuit Based on Magnetic Amplifier

A Pre-amplifier Circuit Design for Array Induction Logging Tool(MIT 5530)

Weak Current Signal Detection Device Based on Embedded System

The PLL Amplifier Design Based on Analog Multiplier

The Digital-Assisted Charge Amplifier: A Digital-Based Approach to Charge Amplification

Design and performance of a low-noise, low-power consumption CMOS charge amplifier for capacitive detectors

Design and analysis of a piezo-actuated hydraulic micro-displacement amplifier with high bandwidth and large amplification ratio