Abstract:Amplifiers are widely used in signal receiving circuits, such as antennas, medical imaging, wireless devices and many other applications. However, one of the most challenging problems when building an amplifier circuit is the noise, since it affects the quality of the intended received signal in most wireless applications. Therefore, a preamplifier is usually placed close to the main sensor to reduce the effects of interferences and to amplify the received signal without degrading the signal-to-noise ratio. Although different designs have been optimized and tested in the literature, all of them are using larger than 100 nm technologies which have led to a modest performance in terms of equivalent noise charge (ENC), gain, power consumption, and response time. In contrast, we consider in this paper a new amplifier design technology trend and move towards sub 100 nm to enhance its performance. In this work, we use a pre-well-known design of a preamplifier circuit and rebuild it using 45 nm CMOS technology, which is made for the first time in such circuits. Performance evaluation shows that our proposed scaling technology, compared with other scaling technology, extremely reduces ENC of the circuit by more than 95%. The noise spectral density and time resolution are also reduced by 25% and 95% respectively. In addition, power consumption is decreased due to the reduced channel length by 90%. As a result, all of those enhancements make our proposed circuit more suitable for medical and wireless devices.

The PLL Amplifier Design Based on Analog Multiplier

Low Noise CMOS Front-End Amplifier Used in Detection of Extracellular Neural Signals (ENG)

Design of signal preamplifier circuit for fluorescence detection system in quantitative PCR instrument.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A Pre-amplifier Circuit Design for Array Induction Logging Tool(MIT 5530)

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

Design of X-band Low Noise Amplifer

Design and Simulation of Pre-amplification Circuit for IMS Current Signals

Ultra-Low Frequency Difference Signal Multiplication Based on PLL

Analysis and design of a weak charge signal amplifier circuit

Research and Implementation of the Key Technology of Digital Lock-in Amplifier

Optimal Design and Research of Small Signal Amplifier with Low Power Consumption

Design of the Digital Power Amplifier

A High Dynamic Range Linear Rf Power Detector with A Preceding Lna

A 21-to-41-GHz High-Gain Low Noise Amplifier With Triple-Coupled Technique for Multiband Wireless Applications

An improved Phase/Frequency Detector and a glitch-suppression charge pump design for PLL applications

Design of Pre-amplifier in Piezoelectric Signal Acquisition

An efficient design of 45-nm CMOS low-noise charge sensitive amplifier for wireless receivers