Abstract:The peak luminosity of the super Tau-Charm facility (STCF) proposed by the Chinese particle physics community is about an order of magnitude greater than the present Tau-Charm factory. In the STCF, the micro-pattern gas detector (MPGD)-based Ring Imaging CHerenkov (RICH) detector used for Particle IDentification (PID) demands a new high integration, low dead time, and high-performance application-specific integrated circuit (ASIC). In this article, the design and testing of a 32-channel mixed-signal readout ASIC prototype is presented. Each channel consists of a charge-sensitive amplifier (CSA)-based analog signal processing circuit, a valid signal discriminator, a switched capacitor array (SCA), a 10-bit Wilkinson ADC, and a digital core. The ASIC provides charge measurement ranges from 48 fC to 10 pC with automatic calibration, five programmable peaking times from 70 ns to , and can be operated at a sampling frequency of up to 240 MHz. The ASIC has been fabricated in a CMOS technology and all the test results meet the requirements. In the case of an input capacitance of 20 pF and a charge collection time of 100 ns, the charge resolution of the full-scale signal is better than 0.38% and the time resolution of the 1/3-scale signals is better than 0.78 ns for all charge measurement range options, while the power consumption is less than 20 mW per channel. In particular, the equivalent noise charge (ENC) is 627 e + 18.8 e/pF for the 48 fC charge measurement range. Besides, the maximum repetition event rate capability per channel is up to 125 kHz.

A Main Amplifier and Peak Hold Circuit for Periodic Sampling of High Count Rate

High gain, high speed OTA for S/H circuit in 14-b 100-MS/s Pipeline ADC

A Main Amplifier Circuit and Data Acquisition System for Charged Particle Detector Array

A sample and hold circuit for high speed ADCs

High Sensitivity and Wide Dynamic Range Analog Front-End Circuits for Pulsed TOF 4-D Imaging LADAR Receiver

Design of a Programmable Gain Waveform Digitization Instrument for Detector Calibration

Design and Experimental Validation of an Integrated Multichannel Charge Amplifier for Solid-State Detectors With Innovative Spectroscopic Range Booster

A 32.5-Gs/s Sampler with Time-Interleaved Track-and-Hold Amplifier in 65-Nm CMOS

High Time Resolution, Low-Noise, Power-Efficient, Charge-Sensitive Amplifier in 40 nm Technology

A Mixed-Signal Micromegas Readout ASIC Prototype With Automatic Charge Measurement Range Calibration

Detection and Automatic Adjustment Circuit of Current True Peak Value of the Dynamic Excitation Power Amplifier

A Multichannel Pulse Height Analyzer by Using Look-up Table for the Particle Radiation Detection

High dynamic range base design and characterization of an 8-inch photomultiplier tube CR365-02-2 for the LHAASO-MD experiment

Real-time Data Acquisition and Processing System for MHz Repetition Rate Image Sensors

A Low Noise and Wide Dynamic Range Preamplifier for HPGe Detectors

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout

Detection And A/D Conversion For 10ghz Periodic Signals With Optical Sampling

Study of Built-in Amplifier Performance on HV-CMOS Sensor for the ATLAS Phase-Ii Strip Tracker Upgrade

Sixteen Multiple-Amplifier Sensing Charge-Coupled Devices and Characterization Techniques Targeting the Next Generation of Astronomical Instruments

Studies of A Solid Detector Array for High Energy X-Ray Imaging System Based on Ma-Pmt

Silicon Photomultiplier selection for Large Array of Imaging Atmospheric Cherenkov Telescopes