Abstract:The front-end electronics (FEE) of the Compact Muon Solenoid (CMS) is needed very low power consumption and higher readout bandwidth to match the low power requirement of its Short Strip application-specific integrated circuits (ASIC) (SSA) and to handle a large number of pileup events in the High-Luminosity Large Hadron Collider (LHC). A low-noise, wide bandwidth, and ultra-low power FEE for the pixel-strip sensor of the CMS has been designed and simulated in a 0.35 µm Complementary Metal Oxide Semiconductor (CMOS) process. The design comprises a Charge Sensitive Amplifier (CSA) and a fast Capacitor-Resistor-Resistor-Capacitor (CR-RC) pulse shaper (PS). A compact structure of the CSA circuit has been analyzed and designed for high throughput purposes. Analytical calculations were performed to achieve at least 998 MHz gain bandwidth, and then overcome pileup issue in the High-Luminosity LHC. The spice simulations prove that the circuit can achieve 88 dB dc-gain while exhibiting up to 1 GHz gain-bandwidth product (GBP). The stability of the design was guaranteed with an 82-degree phase margin while 214 ns optimal shaping time was extracted for low-power purposes. The robustness of the design against radiations was performed and the amplitude resolution of the proposed front-end was controlled at 1.87% FWHM (full width half maximum). The circuit has been designed to handle up to 280 fC input charge pulses with 2 pF maximum sensor capacitance. In good agreement with the analytical calculations, simulations outcomes were validated by post-layout simulations results, which provided a baseline gain of 546.56 mV/MeV and 920.66 mV/MeV, respectively, for the CSA and the shaping module while the ENC (Equivalent Noise Charge) of the device was controlled at 37.6 e- at 0 pF with a noise slope of 16.32 e-/pF. Moreover, the proposed circuit dissipates very low power which is only 8.72 µW from a 3.3 V supply and the compact layout occupied just 0.0205 mm2 die area.

High Time Resolution, Low-Noise, Power-Efficient, Charge-Sensitive Amplifier in 40 nm Technology

Low Noise CMOS Front-End Amplifier Used in Detection of Extracellular Neural Signals (ENG)

Design of Low Noise CMOS Charge Sensitive Amplifier ASIC

Design and performance of a low-noise, low-power consumption CMOS charge amplifier for capacitive detectors

Design and Test Results of A Low-Noise Readout Integrated Circuit for High-Energy Particle Detectors

Low-Power High Time Resolution Charge Detection ROIC in 40nm CMOS Technology

Particle Detector Readout Integrated Circuit of 0.18 Mu M Technology with 164 E Equivalent Noise Charge

Particle Detector Readout Integrated Circuit of 0.18μm Technology with 164 E Equivalent Noise Charge

Low-noise CMOS Charge-Sensitive Preamplifier

A low noise charge sensitive amplifier with adjustable leakage compensation in 0.18µm CMOS process

A Fully Integrated CMOS Readout Circuit for Particle Detectors

Simple power-efficient preamplifier-shaper channel for readout interface of silicon detectors

An 8.72 µW Low-Noise and Wide Bandwidth FEE Design for High-Throughput Pixel-Strip (PS) Sensors

A Low Noise Fully-Integrated Readout Electronic with Pile-Up Rejector for Particle Detector.

A Low Noise Readout Asic for Cdte/Cdznte Detectors

Development Of A Low Noise Readout Asic For Czt Detectors For Gamma-Ray Spectroscopy Applications

An efficient design of 45-nm CMOS low-noise charge sensitive amplifier for wireless receivers

A 12-bit 30 MS/s SAR ADC in 180 nm CMOS for PMT signal readout

Charge-sensitive front-end electronics with operational amplifiers for CdZnTe detectors

Design and preliminary test results of the charge sensitive amplifier for gain-less charge readout in high-pressure TPC

MiniCACTUS: A 65 ps Time Resolution Depleted Monolithic CMOS Sensor