Abstract:State-of-the-art (SoA) electronic readout for silicon photomultiplier (SiPM)-based scintillation detectors that demonstrate experimental limits in achievable coincidence time resolution (CTR) leverage low noise, high frequency signal processing to facilitate a single photon time response that is near the limit of the SiPMs architecture. This readout strategy can optimally exploit fast luminescence and prompt photon populations, and promising measurements show detector concepts employing this readout can greatly advance PET detector CTR, relative to SoA in clinical systems (~200 ps FWHM). However, the technique employs power hungry components which make the electronics chain impractical for channel-dense TOF-PET detectors. We have developed and tested a low noise and high frequency readout circuit which is performant at low power and consists of discrete elements with small footprints, making it feasible for integration into TOF-PET detector prototypes. A 3x3 mm2 Broadcom SiPM with this readout chain exhibited sub-100 ps single photon time resolution (SPTR) at 10 mW of power consumption, with a minor performance degradation to 120±2 ps FWHM at 5 mW. CTR measurements with 3x3x20 mm 3 LYSO and fast LGSO scintillators demonstrated 127±3 ps and 113±2 ps FWHM at nominal power dissipation and 133±2 ps and 121±3 ps CTR at 5 mW. BGO crystals 3x3x20 mm 3 in size show 271±5 ps FWHM CTR (1174±14 ps FWTM) at optimal power dissipation and 289±8 ps (1296±33 ps FWTM) at 5 mW. The compact and low power readout topology that achieves this performance thereby offers a platform to greatly advance PET system CTR and also opportunities to provide high performance TOF-PET at reduced material cost.

Low-Power High Time Resolution Charge Detection ROIC in 40nm CMOS Technology

High Time Resolution, Low-Noise, Power-Efficient, Charge-Sensitive Amplifier in 40 nm Technology

Design of Particle Detector Readout Circuit With High Performance and Low Power Dissipation

A 48 mW DROIC with 15-bit pixel-level ADC for 640x512 mid-wave infrared imagers

A high efficient analog charge delay line for high performance CMOS readout integrated circuits with TDI function

Column-level Passive Sample and Column-Shared Active Readout Structure for High Speed, Low Power ROIC

Low Power Design Orienting 384×288 Snapshot Infrared Readout Integrated Circuits

A LOW POWER HIGH RESOLUTION ROIC DESIGN WITH 14-BIT COLUMN-LEVEL ADC FOR 384 × 288 IRFPA

A Low-Power DROIC with Extended-Counting ADC for Uncooled Infrared Silicon Diode Detectors

Design and performance of a low-noise, low-power consumption CMOS charge amplifier for capacitive detectors

Low Power Design Of Column Readout Stage For 320x288 Snapshot Infrared Roic

A Low-Power Optoelectronic Receiver IC for Short-Range LiDAR Sensors in 180 nm CMOS

A Low Power High Speed Readout Circuit for 320×320 IRFPA

A 48 mW DROIC with 15-bit pixel-level ADC for 640×512 mid-wave infrared imagers

Particle Detector Readout Integrated Circuit of 0.18 Mu M Technology with 164 E Equivalent Noise Charge

Low power implementation of high frequency SiPM readout for Cherenkov and scintillation detectors in TOF-PET

A Novel Low-Power Readout Structure for Tdi Roic

A Low Power High Speed ROIC Design for 1024&#x00d7;1024 IRFPA with Novel Readout Stage

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

Particle Detector Readout Integrated Circuit of 0.18μm Technology with 164 E Equivalent Noise Charge

A Low Power Tdc With 0.5ps Resolution For Adpll In 40nm Cmos