Abstract:We present results from the characterization and optimization of Skipper charge-coupled devices (CCDs) for use in a focal plane prototype for the Southern Astrophysical Research Integral Field Spectrograph (SIFS). We tested eight Skipper CCDs and selected six for SIFS based on performance results. The Skipper CCDs are 6k × 1k, 15 μm pixels, thick, fully depleted, p-channel devices that have been thinned to ∼250 μm, backside processed, and treated with an anti-reflective coating. We demonstrate a single-sample readout noise of <4.3 e − rms pixel −1 in all amplifiers. We optimize the readout sequence timing to achieve a readout noise of 0.5 e − rms pixel −1 after 74 non-destructive measurements, which can be accomplished in a region covering 5% of the detector area in a readout time of <4 minutes. We demonstrate single-photon-counting in all 24 amplifiers (four amplifiers per detector) with a readnoise of σ N ∼ 0.18 e − rms pixel −1 after N samp = 400 samples, and we constrain the degree of nonlinearity to be ≲1% at low signal levels (0 e − to 50 e − ). Clock-induced charge (CIC) remains an important issue when the Skipper CCD is configured to provide a large full-well capacity. We achieve a CIC rate of <1.45 × 10 −3 e − pixel −1 frame −1 for a full-well capacity of ∼900 e − , which increases to a CIC rate of ∼3 e − pixel −1 frame −1 for full-well capacities ∼40,000–65,000 e − . We also perform conventional CCD characterization measurements such as charge transfer inefficiency (3.44 × 10 −7 on average), dark current (∼2 × 10 −4 e − pixel −1 s −1 ), photon transfer curves, cosmetic defects (<0.45% "bad" pixels), and charge diffusion (point-spread function < 7.5 μm) to verify that these properties are consistent with expectations from conventional p-channel CCDs used for astronomy. Furthermore, we provide the first measurements of the brighter-fatter effect and absolute quantum efficiency (≳80% between 450 and 980 nm; ≳90% between 600 and 900 nm) using Skipper CCDs.

Sixteen Multiple-Amplifier Sensing Charge-Coupled Devices and Characterization Techniques Targeting the Next Generation of Astronomical Instruments

Multi-Amplifier Sensing Charge-coupled Devices for Next Generation Spectroscopy

Single-Quantum Measurement With a Multiple-Amplifier Sensing Charge-Coupled Device

Fast Single-Quantum Measurement with a Multi-Amplifier Sensing Charge-Coupled Device

Characterization and Optimization of Skipper CCDs for the SOAR Integral Field Spectrograph

Precision Projector Laboratory: Detector Characterization with an Astronomical Emulation Testbed

Improvement of Spectroscopic Performance using a Charge-sensitive Amplifier Circuit for an X-Ray Astronomical SOI Pixel Detector

Astronomical Spectroscopy with Skipper CCDs: First Results from a Skipper CCD Focal Plane Prototype at SIFS

Status of SuperSpec: A Broadband, On-Chip Millimeter-Wave Spectrometer

The Simons Observatory Microwave SQUID Multiplexing Detector Module Design

A multi-channel silicon package for large-scale skipper-CCD experiments

Towards a New Generation of Monolithic Active Pixel Sensors

Beyond CCDs: Characterization of sCMOS detectors for optical astronomy

Design and Experimental Validation of an Integrated Multichannel Charge Amplifier for Solid-State Detectors With Innovative Spectroscopic Range Booster

The Simons Observatory: Studies of Detector Yield and Readout Noise From the First Large-Scale Deployment of Microwave Multiplexing at the Large Aperture Telescope

Characterization of Transition Edge Sensors for the Simons Observatory

Skipper-CCD Sensors for the Oscura Experiment: Requirements and Preliminary Tests

Light-Trap: A SiPM Upgrade for VHE Astronomy and Beyond

Achieving Single-Electron Sensitivity at Enhanced Speed in Fully-Depleted CCDs with Double-Gate MOSFETs

The path toward 500 $μ$m depletion of AstroPix, a pixelated silicon HVCMOS sensor for space and EIC

On the use of electron-multiplying CCDs for astronomical spectroscopy